0
I assume you have the 2.5L MPI engine. The fan switch is located in the neck of the water pump. It will have a 2 wire connector running to it the connects via a plastic retainer. Disconnect that then remove the switch. You will need to use a wrench a socket will not fit. Hope that helps.
What else can I help you with?
How do you remove the heater fan switch on a 1999 ford econoline?
Need to know how to remove heater fan on 1999 ford e 150 van with small v6 engine
Where in the electrical system on a ford probe will cause the fan to stop even though there is electric at the fan and at the fan speed switch and a new fan resistor ac will work heating system works?
Should be thermostat controlled-meaning it is supposed to stop at times
How do you remove a fan blade from a 1998 Ford Explorer?
how do you remove a fan blade from a 1998 ford explorer
Where is engine cooling fan switch for 2002 ford focus?
on the radiator fan
Your fan switch wont work but mt fan motor works on your ford van can you put a toggle switch on it?
Yes.
Where you your fan relay 1996 Ford Thunderbird?
The 1996 Ford Thunderbird fan relay switch is attached to the electric fan motor. The fan motor is attached to the fan blades.
The location of the heat and air condition fan on a ford probe 1989?
Under the passenger side of the dashboard.
How do you replace a fan clutch on a 2003 Ford Explorer?
How to remove fan clutch on 2003 ford explorer
Where is the cooling fan relay located on a 1988 Ford Taurus?
The 1988 Ford Taurus cooling fan relay switch can be found on the front drivers side quarter panel. The fan relay switch should be labeled as such.
1988 FORD ESCORT My fan wont kick on when hot you replaced fan motor thermostat and sensor in therm housing what else is there?
your fan relay switch your fan relay switch
What are the steps to replace a ceiling fan pull chain switch for a 3-speed fan?
To replace a ceiling fan pull chain switch for a 3-speed fan, follow these steps: Turn off the power to the fan at the circuit breaker. Remove the fan's light kit or housing to access the switch. Disconnect the wires from the old switch. Remove the old switch and replace it with a new one. Connect the wires to the new switch according to the wiring diagram. Reassemble the fan and turn the power back on to test the new switch.
What is the process for replacing a Harbor Breeze ceiling fan switch?
To replace a Harbor Breeze ceiling fan switch, first turn off the power to the fan. Remove the fan's housing cover to access the switch. Disconnect the wires from the old switch and remove it. Install the new switch by connecting the wires in the same way. Secure the switch in place and reassemble the fan. Turn the power back on and test the new switch to ensure it is working properly.
