answersLogoWhite

0

first of all close the sunroof fully, then pull down the trim cover (held on by pop type clips). Then you will see 4 10mm nuts, 1 in each corner. Remove them and then carefully lift up the sunroof to remove.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Will a sunroof from a 1995 Ford Probe GT fit into a 1994 Ford Probe SE?

Yessir, it will.


How do you change the sunroof motor on a 1996 Ford Probe GT?

you have to remove the rear quater panel pillars and clips and the three clips in the rear headliner and simplely pull down on the headliner and it will be right there  


Does anything need to be taken off to remove a starter on 1989 ford probe?

does anything need to be taken off to remove a started on 89 ford probe


Where do you put brake fluid in a 1994 Ford Probe?

The 1994 Ford Probe has a brake fluid reservoir that should be mounted on the drivers side firewall. Remove the cap on top to add fluid.


What do you have to do to change a fuel pump on a ford 1993 probe the engine is a 2.0?

Remove fuel tank Remove fuel tank


When was Ford Probe created?

Ford Probe was created in 1989.


How do you remove main fuse block on a 1994 Ford Probe GT?

10mm sockett ranch


How do you manually close a sunroof on a 1996 Ford Explorer?

how do you manually close a sunroof in a 1996 ford explorer.


Can you remove the manual transmission out of 93 ford probe se and put in a 96 ford probe gt v6 manual transmission that's shot?

Negative......V6 uses different trans than I4


How do you replace the ball joints in a 1990 Ford Probe?

This is not an easy job to do yourself if you only have little knowlege. Get the Haynes Manual MAZDA 626 & MX6 FORD PROBE 1993_2001. No. 61042 This will tell you in detail how to remove & replace the balljoints . This is not an easy job to do yourself if you only have little knowlege. Get the Haynes Manual MAZDA 626 & MX6 FORD PROBE 1993_2001. No. 61042 This will tell you in detail how to remove & replace the balljoints . This is not an easy job to do yourself if you only have little knowlege. Get the Haynes Manual MAZDA 626 & MX6 FORD PROBE 1993_2001. No. 61042 This will tell you in detail how to remove & replace the balljoints .


Will a 1995 Ford Probe transmission fit in a 1994 Ford Probe?

yes....


How do you install a supercharger on a Ford probe?

Can a supercharger work on a 97 ford probe