First, have plenty of time set aside - it takes a while to get all of the screws removed and requires patience when getting it to come off around the steering column. It is a very tight fit there. I am not a mechanic and have been able to do this a few times when necessary ... removal is probably about a 30 minute project alone.
The 2005 Jeep Grand Cherokee dashboard is held in place by eight retaining clips. Pry outward on each retaining clip, one at a time.
To remove the dashboard on a 2002 Jeep Grand Cherokee, start by disconnecting the negative battery cable to prevent any electrical issues. Next, remove all screws and bolts securing the dashboard, including those found in the glove compartment and around the instrument cluster. Carefully pry off any trim pieces and disconnect any electrical connectors attached to the dashboard. Finally, gently pull the dashboard away from the frame, taking care not to damage any clips or wiring.
The 2002 Jeep Grand Cherokee ignition key brain box is located behind the dashboard. The brain box will be on the drivers side of the dashboard.
remove the dashboard face then you should beable to remove and put in your new stereo u may have to take out the heater cointroll unit to get do that
so you replace the light
The 2001 Jeep Cherokee crossbar is welded to the frame of the vehicle. You will need to use a cutting torch to remove the crossbar.
I need to know asap how to remove a trasmission oil pan on a 1991 jeep Cherokee Laredo? Thank you!
I mean how do you disassemble the fan blower in a 1998 Jeep Grand Cherokee Laredo. how do you remove the blower fan from the car in the Grand Jeep Cherokee Laredo.
centre top dashboard (red dome)
Open the passenger door. It is inside the panel you see at the end of the dashboard.
1996-2001 OBD-II XJ Cherokee, the TCM is under the dashboard, near the Drivers right kneecap.
You can if you remove the rear drive shaft.