0
What else can I help you with?
Can you remove the fuel pump on a 2007 Chevrolet Malibu through the back seat?
If there is an access panel, yes. If not you will have to remove the tank.
How do you change battery on 2007 Chevrolet Cobalt?
Open up the trunk Remove the wood/carpet cover in the back. Unbolt the strap for the battery and remove it. Unbolt the bolts on the +/- sides of the battery. Remove the battery.
Where is shift solenoid locate on 2006 Chevy Cobalt ss?
inside the transmission....you have to remove the side panel to get to it. It is a job for a dealer...cost will be about $800. The A-frame needs dropped along with the rack, and the tranny tilted back.
I got Microsoft office 2007 but I want to go back to my Microsoft 2003 how would you do that?
You would need to unistall Office 2007. To do that go to the control panel/Programs/Add remove programs/ click on office 2007 and remove it. Then if you have not unistalled office 2003, it should still be there.
How do you get a palm treo back off?
With the back panel facing you so you can read the word Palm, press the lower-right corner of the back panel with your right thumb to release the panel. Remove the panel.
How do you remove ecu from 93 ls 400?
Remove Lower Dash Panel passenger side. Remove glove box. Remove middle dash panel (below glove box). ECU is attached to the back of middle dash panel.
How do you remove inside back panel of 2007 Jeep Compass?
To remove the inside back panel of a 2007 Jeep Compass, start by removing any screws or fasteners that may be securing the panel, typically located near the edges or behind any covers. Use a trim tool or flathead screwdriver to gently pry the panel away from the body, being careful not to damage the clips. Once loose, disconnect any electrical connectors if applicable, and then lift the panel away from the vehicle. Always refer to the vehicle's service manual for specific instructions and locations of any hidden fasteners.
How do you remove the driver side door panel on a 2007 Colorado?
Remove the two vertical Phillips head screws in the grab handle. Remove the window handle if equipped. Remove/ unplug the electric mirror/ window switches if equipped. Grab the doors at the bottom and pull hard. Then work you way around the left and right side of the door panel pulling on the panel. There are some white plastic push pins on the back of the panel that hold it to the door. When all of the pins are loose, lift the panel upwards and remove it. This is a less than 5 minute job.
How do you remove an explorer back side door panel to see why window will not hold up?
You must remove door panel and replace window regulator.
How do you get the back speakers out in a 2000 silverado?
Remove the rear door panel.
How do you replace rear wiper motor 2007 Subaru outback?
How do I replace the rear wiper motor or just remove the rear panel on the back window to see if my rear wiper motor is unplugged on my 2007 Subaru Outback? Thanks!
How do you change the handle on a 2002 ford explorer on the back hatch?
if its equiped with a door panel then you have to remove it. Once removed, there should be access holes to get to the back of the handle to remove it. the door panel will probably have a few screws in it. There are either clips holding the panel on which you can just pull hard on the panel to remove or there are plastic hooks molded to the panel in which you have to pull up and out to remove the panel. Just pull the panel up a little and peek in to see whats holding it on. Once removed there should be access holes all over the place to remove the handle.
