0
The dash actually comes out as an assembly. In other words you wont be removing a lot of stuff from the dash to get it out. Remove the steering column. (4 nuts on the bottom, one steering sector shaft bolt, shift cable, and several electrical connectors, and it's out) There are three 9/32nds screws across the top of the dash under the speaker grills and a trim cover in the middle. Behind each kick panel there is a bolt, remove them. Above steering column area, beneath the speedometer there is either a bolt or nut. There may be a bolt or nut under the middle of the dash in the floor tunnel area. That should be all the bolts and nuts. You will need to disconnect the speedo cable, ad all wiring harness and vacuum connectors as you pull the dash away from the firewall. You will need to use a lifting motion as you pull the driver's side of the dash away because there is a reinforcement bracket that you have to come up over. If you are removin the heater core, you dont even have to pull the dash all the way out. You can swing it away on the passengers side, set it on the passenger's seat and leave the driver's side pretty much in place. That will get you access behind to pull out the heater case. If you do that, be careful that you disconnect the battery, so that a light bulb under the dash doesn't burn a hole in your seat.
What else can I help you with?
How do you change the dash lamp in a 2002 Mercury Sable?
Might be able to get at in from underneath but probably will have to remove the dash cover
Remove a dash from a 1997 Mercury Sable?
In order to remove a dash from any vehicle you will need to do one of two things. First, take it to the dealer to get it removed or look at the manual instructions to see if they explain how to remove it or if you can remove the dash.
Why does 95 mercury sable have no dash lights and no tail lights?
It does have both tail lights as well as dash lights
How do you change a light in the dashboard on a 2002 mercury sable?
Might be able to get at in from underneath but probably will have to remove the dash cover
Where is the headlight sensor located on a 2001 Mercury Sable?
on the dash
Where is the valet switch on a Mercury Sable?
under dash on drivers side
Where is the obd-1 or obd-2 connector on your 1996 Mercury Sable?
The 1996 Mercury Sable the OBD 2 connector is under drivers dash next to kick panel
Where is the auto lamp sensor on a Mercury Sable?
its a gray bubble on the dash close to the glass
How do you remove dash board 1995 mercury sable?
To remove the dashboard from a 1995 Mercury Sable, start by disconnecting the battery to ensure safety. Next, remove any screws and bolts securing the dashboard, which are typically located in the glove compartment, around the instrument cluster, and under the dash. Carefully pry off any trim pieces and disconnect electrical connectors for the gauges and controls. Finally, gently pull the dashboard away from the vehicle, ensuring all connections are detached.
Where is the horn relay on a 1998 Mercury Sable?
The horn relay for a 1998 Sable is on the back of the distribution block. The block is under the dash on the drivers side.
Direcetion on how to replace the heater core on a 1997 sable?
remove the entire dash
The parking lights and dash lights are out on your '99 Mercury Sable where can you get a wiring diagram for this?
Start with the headlamp switch.
