answersLogoWhite

0

The first step is to remove the outer trim surrounding the electronics panel; you can use a screwdriver to gently pry off the trim. There are a total of six clips holding the panel in place, two on top and bottom, and one on each side. Once the panel is off you can unplug the cables attached to the control knobs. Finally there are two screws on the bottom of the factory installed CD player, remove them and you should now have the device completely removed.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you remove the dash board to install a CD player in a 2002 Ford Explorer?

I need an answer to my question. how do you remove the dashboard to install CD player in a 2002 ford explorer. thank you.


How do you install a CD player in a 2003 ford explorer?

First of all you should buy a Double Din Cd player then remove the plastic things arround the current cassette player to remove the old one , then you can easily put the new player that will fit exactly the empty place ..I've test it and I've installed a Double Din JVC CD and cassette player , It is PERFECT ..Good Luck.


How do you remove the dash board to install a CD player in a 1994 Ford Explorer?

Should be little holes in the face of your factory deck... you can go buy the special little tools to put into these holes and the deck will slide out.


How do you remove the CD player from a 1998 Chevy Blazer?

is it factory or an add on?


How do you remove the factory cassette player from a 1994 Mitsubishi Magna?

bash it with a hammer.


Factory amp location in a 2003 ford explorer?

It is located behind the rear panel on the passenger side. You have to remove the entire panel to access it.


How do you remove a factory CD player from 2000 Honda CR-V?

To remove a factory CD player from a 2000 Honda CR-V first inspect the center console of your vehicle. There should be several mounting screws holds the CD player. Remove them and proceed to slide the unit out of the center console. Lastly remove the wiring clip behind the radio.


How do you replace spark plug Ford Explorer?

The spark plugs on a Ford Explorer are replaced by first disconnecting the battery. Remove the spark plug using a spark plug socket. Replace with the factory recommended spark plug.


How do you get the factory Cd player out of a 1999 Chevy Malibu?

you are better off leaving the factory CD player because the theft system, pwr locks, etc. are all connected through the CD player and will not work if u remove it unless u re-wire the factory CD player to the trunk.


How do you remove the spare tire on 2003 ford explorer?

how to remove the spare on a 2003 explorer


How do you remove the word factory on the television screen?

how to remove the word " factory" on the television screen


How do you take out the factory stereo on a 1991 Holden Apollo?

Remove the retaining cover from your factory stereo. Remove the factory stereo retaining bolts. Slide the factory stereo out. Remove the wiring harness and the antenna cable from the back of the factory stereo.