answersLogoWhite

0

you are going to need a 10mm and an 11mm scoket and undo the center bolt on the connecter and then there are to side bolts and that you pull it out.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the ECM located on a 1999 Mercury Sable?

The ECM in a 1999 Mercury Sable is located on the inside of the vehicle on the passenger side. It is located under the kick plate.


How do you replace the ECM computer on Mercury Sable 19955?

you have to remove it and and reinstall the new one and have it progamed to the car spec.


Where is ECM located on 1986 Mercury Sable?

Behind the glovebox


Why does your 89 Ford Taurus have a Mercury Sable ECM?

Ford Motor Company makes Fords, Lincolns & Mercurys. The Mercury Sable is the same car as a Ford Taurus, just different names and a little different trim. they use the same parts.


Where is the location ecm on a 1996 Nissan maxima?

were is the location ecm on a 1996 Nissan maxima


Where is the ecm on a 1996 Toyota land cruiser?

location of the ecm on the Toyota land cruiser 93


Where is the ecm located in a 1999 mercury grand marquis?

In a 1999 Mercury Grand Marquis, the Engine Control Module (ECM) is typically located in the engine compartment, near the firewall on the driver's side. It is housed in a black plastic case and is mounted to the vehicle's body. To access it, you may need to remove any covers or components obstructing it.


How do you pull the ecm off an 85 Celebrity?

The ECM is located under the dash behind the glove box. To remove the ECM. 1. Remove the glove box. There is a release under the box, push it up to release it. 2. The key should be off and preferably pull the battery cable before removing the ECM. Working thru the glove box opening: 3. Release the latches and remove the wire connectors. 4. The ECM is held in with bolts, remove them and the ECM will pull out. Reverse the procedure to reinstall the ECM.


Does the ECM on a 1996 Pontiac Grand Am have anything to do with the AC?

no


How do you replace the ecm on a 1995 Chevrolet beretta?

Remove the glove box. Look under the dash. You should see the ECM inside a plastic enclosure, bolted to the firewall. Remove all bolts, unplug the ECM from the harness, and it will come right out. Install the new ECM in the reverse order to remove the old one.


Will a 1996 firebird ecm work in a 1992 sunbird ecm?

1992 sunbird is obd1,1996 firebird is obd2.Will not work.


Where is the ecm on a 1996 olds ciera?

It is located directly on the firewall behind the glove box. It is easier to remove with less chance of damaging the ecm holder if you remove the screws on the front of the glove box, the screw holding the glove box retaining cable, and the bottom screws holding up the bottom cover just below the glove box. This will be easy since all of the screws are 7mm screws. The screws that hold the pins onto the ecm are also 7mm. You will then remove the ecm from the bottom but by taking the glove box out you can actually see what you are doing.