0
What else can I help you with?
How do you remove a rear brake calaper on a 1980 Corvette?
there are factory rivets which have to be drilled out
Remove rear brake rotors on a 1980 model corvette?
there are factory rivets which have to be drilled out
How do you replace the third door handle on a 2000 S-10?
Remove the door trim panel. Remove the inside door handle rod. Remove the inside door handle retaining rivets. Remove the inside door handle from the door by sliding the handle rearward.
How do you get the window motor and gearbox out of a 1989 Mercury Grand Marquis?
The motors were installed with rivets at the factory. You need to use a drill and drill out the rivets to remove the motor. The replacement motors come with screws and bolts to replace the rivets.
How do you repair an interior door handle on a 1998 Chevy Silverado?
It is not too hard. You will have to remove the door panel, then you will see how the interior handle is riveted to the metal door frame work. You will need to drill these rivets out and install the new handle with either rivets or screws.
How do you remove a 1994 thunderbird exterior door handle?
you got to drill out the rivets from the outside and that's about it then there is a clip on the inside that you need to unhook to do that you need to remove the door panel that's it
How do you remove altima hood rod holder fasteners?
The hood rod holders are held in place with rivets. You can remove the rivets with a small grinder. When the rivets are removed the fastener will come off.
What is the metal piece that fasten the handle to the tang?
The metal piece that fastens the handle to the tang is called a rivet. Rivets are permanent mechanical fasteners that hold the handle securely in place on the blade of a knife or tool.
How do you replace the inside drivers door handle on a 97 Chevy truck?
I don't know if you asked this in another question that I just answered but here is what I wrote "Need a rivet gun and rivets. Remove inside door panel...(need to remove a few screws. Panel is attached by plastic rivets so pull hard but gentle. Start from bottom and work around and up. Then slide it up to remove. I don't know if your door will have it but you might need to remove a metal plate (hexscrews) Now it gets a little tricky to explain. You'll see a thin metal wire attached to the door handle with a plastic lock nut (needle nose pliers to remove. You might also need a drill to drill out the rivets holding the handle. Reattach the handle to the wire BEFORE replacing the rivets. Then work yourself back to installing the door panel.I just did this a few weeks ago with power locks and windows.
Can you replace the drivers inside door handle with the rear passenger inside door handle of a 97 Yukon?
yes remove door panel drill rivets replace with new door handel from gm dealership
How do you change the exterior door handle on a 1998 Ford Explorer Sport?
Remove the door panel. Drill out the rivets in the exterior handle with a 1/4 drill. Carefully pull the handle out and disconnect the pull rod. Use small bolts and lock nuts to reattach.
How do you remove power window motor in 1991 f150 xlt?
Remove door trim screws, one in handle one next to side mirror. Remove power window door lock trim, the metal piece is attached to the plastic part. Lift whole door trim up at the rear and down at the front to slide out from door opener handle. Remove the plastic sheeting and any insulation. remove the glass from the lifter arm. Remove wiring.Drill out the 3 rivets that hold the motor, pull out and replace. 1/4 20 bolts and nuts work if you don't have rivets.
