answersLogoWhite

0

If it's like the 2000 Venture there are two wing nuts on each light that have to be removed first. Then you have to grab hold and pull forward on the whole assembly until it pops loose. There is another wing nut that holds the two pieces of the assembly together, but you only need to remove this when you put it back in. It's a very stupid design that lends itself to being damaged or you getting a finger or something else injured. I wish I could get paid the money these idiots got paid for coming up with some of these dumb ideas.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you remove the headlight switch from a 2003 Chevy venture van?

To remove the headlight switch from a 2003 Chevy Venture van, first, disconnect the negative battery cable to ensure safety. Then, use a flathead screwdriver to gently pry off the decorative trim around the switch. Next, remove any screws securing the switch, disconnect the wiring harness from the back, and finally pull the switch out of the dashboard. Reinstall the new switch by reversing these steps.


Would rims from a 2000 Chevy Venture fit a 2003 Chevy Venture?

Yes


Show you a diagram of a water pump for Chevy venture van 2003?

please show me a diagram of a water pump on the engine of a Chevy venture 2003


How do you remove the boot that covers the rear of the headlight assembly of a 2003 Chevy trailblazer?

It pulls off. Sometimes easier to remove the headlight assembly to change the bulb. We have instructions at our forum. www.trailvoy.com Trailblazer enthusiasts!


How do you remove headlight assembly?

How to remove headlight assembly on 2003 Lexus GX470


Where is horn located on 2003 Chevy Malibu?

the horn is easier to get to,if you remove the right side headlight housing!! then you can see horn.


Where is the radiator drain plug on a 2003 Chevy venture?

The drain plug on the 2003 Chevy Venture is located on the bottom edge of the radiator. It is on the side facing the engine.


How do you replace the headlight bulb located on a 2003 Chevy S 10?

Open the hood, remove the two locks that hold the headlight assembly in place, with the two locks removed you can wiggle the headlight assembly out and gain access to the back side of the assembly to remove and replace the headlight bulb.


How do you change radiator in 2003 Chevy venture van?

yes


What is tire pressure for 2003 Chevy Venture?

32 to 35 psi.


How do you replace a headlight 2003 Chevy monte carlo?

To replace the headlight on a 2003 Chevy Monte Carlo, first, open the hood and locate the back of the headlight assembly. Disconnect the electrical connector by pressing the tab and pulling it off. Remove the retaining ring or clips that hold the headlight in place, then carefully pull out the old headlight bulb. Insert the new bulb without touching the glass, reattach the retaining ring, reconnect the electrical connector, and test the headlight.


Tune up on a 2003 Chevy Venture?

it cost 320.00 at the garage that's what i paid for it on my 2003