answersLogoWhite

0

As much as this sucks you have to take out the dash and it is located on the right side behine a little box.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you replace the heater core on a 1990 Chevy Corsica?

Drain the water from your 1990 Chevy Corsica cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.


Where is the egr valve on a 1990 Chevy Blazer?

yes


How do you get the limited-slip rear end on a 1990 Chevy k 5 blazer apart?

how do you get the limited-slip rear end on a 1990 Chevy blazer k-5 apart


1990 Chevy 4x4 s10 blazer firing order?

i am looking for a diagram of the firing order in a 1997 Chevy s10 blazer 4x4.


How do you change the rotor 1990 Chevy blazer?

Lift the wheel in Question. Remove the tire. Remove the disc brake assembly. pull the rotor off. replace in reverse order.


Where is the block heater cord on a 1990 Chevy 1500?

It does not have one.


What fluid goes in a 1990 K5 CHEVY blazer transfer case?

Dextron II


How much does a 1990 Chevy blazer cost brand new?

There are no new 1990 cars since this is 2017 and that makes a 1990 car very old.


Where is the modulator valve on a 1990 Chevy Blazer?

That transmission does not have a modulator valve on it. It is computer controlled to a point.


Replaced fuel pump on 1990 Chevy blazer and still will not start?

does that year have carb or tb?


How do you remove 1990 fullsize blazer fuel pump?

The fuel pump for the 1990 full size blazer is located inside of the fuel tank. If this model does not have an access plate in the floor of the blazer then the tank will have to be removed to get to the pump.


How do you replace the heater core on a Chevy Caprice 1990?

To replace the heater core on a 1990 Chevy Caprice, begin by disconnecting the negative battery cable and draining the coolant. Remove the dashboard and any components obstructing access to the heater core, such as the center console and the climate control housing. Disconnect the heater core hoses from the engine bay, then unbolt the heater core from the housing and replace it with the new unit. Reassemble everything in reverse order, refill the coolant, and check for leaks.