answersLogoWhite

0

You need a 3/8 drill bit to drill-out the rivets and then replace the motor that way. It might be easier to replace the whole regulator.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is blower motor on 1997 Buick skylark?

where is the blower motor resistor located on 97 buick skylark


How do manually roll up a driver's side front window on a 1998 buick skylark when the motor has gone out?

Remove the inside door panel. Push the window track. Upward, until the window is completely closed. Lock the window linkage in place, so the window will not fall down.


Remove and install window motor and regulator Buick Regal 2002?

Complete instructions with photos:


How do you remove the window motor on the drivers side front door on a 1991 Buick LeSabre?

To remove the window motor on the driver's side front door of a 1991 Buick LeSabre, first disconnect the vehicle's battery to ensure safety. Then, remove the door panel by unscrewing any screws and carefully prying it off to access the window motor. Disconnect the wiring harness from the motor and remove the bolts securing the motor to the door frame. Finally, pull out the motor carefully, making sure not to damage any other components.


How do you replace the motor mount on 1993 Buick Skylark?

To replace the motor mount on a 1993 Buick Skylark, start by securing the vehicle on a flat surface and raising it with jack stands. Support the engine with a jack or engine hoist, then remove the bolts securing the old motor mount to the engine and the frame. Replace it with a new motor mount, ensuring it aligns properly, and tighten the bolts to the manufacturer’s specifications. Finally, lower the engine and remove any supports before testing the installation.


How do you remove the old window motor in a 1990 buick lesabre and replace it?

To remove the old window motor in a 1990 Buick LeSabre, first disconnect the battery to ensure safety. Then, remove the door panel by unscrewing any fasteners and gently prying it off to access the window motor. Disconnect the motor's electrical connector and unbolt it from the regulator, then carefully pull it out. To install the new motor, reverse the process: position the new motor, secure it with bolts, reconnect the electrical connector, and reattach the door panel.


How can you change out the window motor in your 1971 Buick Riviera?

To change the window motor in a 1971 Buick Riviera, first, remove the door panel by unscrewing any fasteners and gently prying it off. Disconnect the window motor's electrical connector and remove the mounting screws to take out the old motor. Install the new motor by reversing the process: secure it with screws, reconnect the electrical connector, and reattach the door panel. Finally, test the window operation before fully securing the door panel.


What kind of oil goes in 92 Buick Skylark?

Standard 10w-30 motor oil goes into a 92 Buick Skylark. It has a capacity of 4.5 quarts of oil for the four cylinder model.


Where are the cables located fro the choke on a 19995 Buick Skylark 3.1 motor?

that engine has no choke


How do you replace the front passenger window motor on a '97 Buick Skylark?

if it's anything like a 92 skylark you have to get the window down far enough (if the motor is dead you can usually turn it manually) to get to the two bolts that hold the window on. Remove the bolts and push the window up. It may have to be held there with some strong tape. if you see bolts holding the motor in then great! remove the motor and the actuator in one piece. If there are rivets then you need to drill out these rivets with a drill not much bigger than the inside part of the rivet.( don't worry the new motor will come with bolts). very carefully switch out the motors on the actuator making sure to have it in the same position. Also, the motor might be riveted to the actuator so the same thing applies to this as well.then replace the motor and actuator then reattach window. on a scale of 1 to 10, with 10 being the hardest i would rate this a six.


How do you change the spark plugs in a 95 Buick Skylark?

I believe there is a slightly finned top on this motor (quad 4). remove the bolts on this and it should remove the finned plate, giving access to the spark plugs underneath.


How do you replace the window motor on a 2002 Chevy Cavalier?

Remove the inside door panel of your 2002 Chevy Cavalier. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install the new window motor.