pop the hood and take the bolt and nut off the linkage up by the firewall. then pull your carpet back on the floor board and undo the four bolts at the bottom of the steering column. then undo the bolts directly under the steering column and disconnect the ignition switch and all electricals of the columnm then pull it out.
On top of the steering column. ////////take a look on the transmission
A printable diagrams can be found in libraries or from computers. A person can also obtain the diagram for the steering wheel column by asking an auto part tech for a print off at a store.
The flasher on a 1994 Pontiac Trans Sport is typically located under the dashboard on the driver's side. It is often mounted near the steering column or fuse box. Check your owner's manual or consult a repair guide for the exact location.
To remove the ignition switch from a 1997 Pontiac Trans Sport, first disconnect the negative battery cable to ensure safety. Next, remove the steering column covers by unscrewing the screws holding them in place. Then, locate and disconnect the wiring harness from the ignition switch, and unscrew the ignition switch from its mounting bracket. Finally, carefully pull the switch out to complete the removal process.
On a 1998 Pontiac Trans Sport van, the flasher unit is typically located under the dashboard, near the steering column. It is often found in the fuse box or close to it, which is usually on the driver's side. To access it, you may need to remove a cover or panel. Check your owner’s manual for specific diagrams and locations for your model.
To remove the steering wheel on a 2001 Trans Am, first disconnect the battery to avoid any electrical issues. Next, remove the airbag by unscrewing the retaining bolts on the back of the steering wheel and carefully disconnecting the airbag connector. Once the airbag is removed, use a steering wheel puller to loosen the steering wheel by removing the center nut and pulling the wheel off the steering column. Make sure to note the alignment for reinstallation.
I don't know how to change the ignition switch but I have some advice. Don't screw with the ignition switch, buy the whole steering column. It will be cheaper and easier to change.
its not where the book says,right besides (left) of the steering column..no, its all the way on the left under the steering column.
To change the rack and pinion on a 1997 Pontiac Trans Sport, first, safely lift the vehicle and remove the front wheels. Disconnect the steering shaft from the rack, then drain the power steering fluid. Remove the mounting bolts for the rack and pinion, disconnect the tie rod ends, and carefully take out the old unit. Install the new rack by reversing the process, ensuring all connections are secure, and refill the power steering fluid before testing the steering.
I need to find a part for the steering and trans lock
The steering wheel will have to come off and then the top cover on the column has to come off and then you will be able to see how the switch comes out, just a few screws.
On a 1992 Pontiac Trans Sport, the cruise control module is typically located under the dashboard on the driver's side, near the steering column. It may also be found on the firewall or attached to the engine compartment, depending on the specific configuration of the vehicle. To access it, you might need to remove some panels or components for better visibility. Always refer to the vehicle's service manual for exact locations and instructions.