0
Where can you find a Steering column exploded view 1988 ford truck?
Wiki User
∙ 14y ago
I need to find a part for the steering and trans lock
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Will a steering column from a 1988 Chevy truck work in a 1988 Chevy suburban?
Yes it will, samething
Where is the data link connector located on a 1988 Mitsubishi pickup truck?
The 1988 Mitsubishi pickup truck data link connector is located on the bottom of the drivers side dashboard. The gauge link connector will be to the left of the steering column.
How do you install a steering column on a 1988 lasabre?
use a manuel
1988 ford bronco steering column 1993 bronco?
NO
Where is Fuse box 1988 Dodge 250 truck?
Behind the plastic panel under the steering column.
1988 gmc safari Steering column switches and ignition key lock cylinder replacement?
1988 gmc safari Steering column switches and ignition key lock cylinder replacement?
How do you remove the whole steering column on a 1988 S-10 Blazer 2x4 drive with tilt steering?
First you have to remove the panel from the bottom of the dash board to be able to get to the steering column bolts. Then, disconnect all of the wiring harnesses from the steering column. After this, go underneath the truck and disconnect the shifter linkage from the transmission. You can then remove the four bolts that hold the column up. Then, carefully slide the column out. Once the shifter linkage is against the firewall, rotate the column until you can pull the linkage through the opening in the firewall.
Will a steering column from a 1988 Chevy caprice fit a 1989?
yes
Where is the fuse box on a 1988 dodge d100?
its under the steering column
Where is turn signal and emergency flasher located in a 1988 Chevy S-10 pickup truck?
Seating area, driver side, passenger side of steering column, under dash, mounted near cigarette lighter. Optional mounting location is under dash, on driver side of steering column.
Where can you find a diagram for the steering column on a 1988 Buick Riveria?
At a GM dealer
Where can you find an exploded view of the tilt wheel steering column for a 1988 Suburban from the tilt knuckle up?
He is right, the LMC cataloge was the only place I found it. But as warning, it is WAY easier to just replace the whole steering column. You can get one at any junk yard for $150, and it will only take a few hours to replace. Tearing into the column you will need a steering wheel puller, a plate compressing tool, and once you get to the tilt part you might as well forget about putting all those springs and little parts back together. the lmc truck cataloge online! then, they will, if you want, send you one for free....some of their pics are better then in my chilton!
