use a manuel
To install the ignition starter switch on the steering column of a 1988 Oldsmobile Cutlass, first, disconnect the battery to ensure safety. Remove the steering column cover and any necessary components to access the ignition switch. Align the new switch with the mounting holes and secure it in place, then reconnect any components you removed. Finally, reassemble the steering column cover and reconnect the battery.
NO
1988 gmc safari Steering column switches and ignition key lock cylinder replacement?
Yes it will, samething
yes
its under the steering column
To change the ignition on a 1988 Chevrolet S10, first disconnect the negative battery cable to ensure safety. Remove the steering column cover by unscrewing the screws, then locate the ignition switch, which is typically mounted on the steering column. Disconnect the wiring harness and remove the ignition switch by unscrewing it. Install the new ignition switch by reversing the steps, reconnect the wiring harness, and reattach the steering column cover before reconnecting the battery.
At a GM dealer
I need to find a part for the steering and trans lock
Inside your steering column , the turn signal lever and hazard flasher button are parts of the multifunction switch that stick out from the steering column
Bottom of dash panel, left of steering column
To tighten the steering column on a 1988 Buick Park Avenue, first, ensure the vehicle is turned off and the key is removed. Remove any necessary panels to access the steering column's mounting bolts. Use a wrench to tighten the bolts securely, ensuring the column is properly aligned. Reassemble any panels you removed, and check for any play in the steering to confirm it’s properly tightened.