The factory alarm is not removable. It is part of the computer programming.
recharging ac system dodge magnum
You can't, it is an integral part of the computer system.
To reset the alarm on a 2005 Dodge Magnum, first ensure the vehicle is unlocked. Insert the key into the ignition and turn it to the "On" position without starting the engine. Press and hold the "Unlock" button on the driver's side door while simultaneously pressing the "Panic" button on the key fob. This should reset the alarm system. If you continue to have issues, consult the owner's manual for specific instructions related to your vehicle's alarm system.
How do you bypass the alarm system on a 1990 Dodge Dynasty?
The alarm can not be disabled by pulling a fuse. The engine computer, ignition switch, interior lighting, and exterior lighting computers are all involved with the alarm. Pulling any of their fuses will disable the car.
You can not disable the factory alarm. It is built in as part of the computers. If it is a aftermarket alarm you should be able to remove it and put the car back stock.
Press unlock on a remote, or turn ignition on with a good key.
look at the CHILTON's book it tells you everything There wasn't a 1996 Magnum.
Remove your center console. and then you will be able to see the whole module
To remove the AC evaporator from a 2000 Dodge Magnum 3500, you'll first need to discharge the AC system and remove the refrigerant. Next, disconnect the battery and remove the dashboard to access the HVAC unit. After that, disconnect the heater core hoses, the AC lines, and any electrical connectors. Finally, unbolt the evaporator from the HVAC housing, and carefully remove it from the vehicle.
Dodge Magnum was created in 1978.
The big box you refer to is called the body computer. It is located on the drivers side behind the dash. You can not shut off the alarm or remove the alarm system if it is a factory installed system. You must find the problem and repair it.