answersLogoWhite

0

Remove the 1 screw behing door handle and the 2 on the armrest. Then pull outward on the bottom of the door panel. There are 8 to 10 plastic retainers holding the plastic to the metal.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you remove the interior door panel from a 2007 Chevy Trailblazer?

The interior door panel is held in place by 10 retaining clips and two screws. Remove the screws of which can be found by the door handle. Pry outward on each retaining clip to remove the door panel.


How do you remove the interior door panels on an 2007 Kia Spectra?

Use a screwdriver, and remove the screws and clips in the door panel. Pull the panel out slowly from the frame, and remove the wire connections, and the panel will fall free.


Is there a fuel pump access panel on a 2007 Chrysler Sebring?

No.


How do you replace a window motor on a 2007 sebring?

To replace the window motor on a 2007 Chrysler Sebring, first, remove the door panel by unscrewing any fasteners and carefully prying it off to access the interior. Next, disconnect the electrical connector from the window motor and remove the bolts securing the motor in place. Replace the old motor with the new one, reattach the electrical connector, and reassemble the door panel. Finally, test the window to ensure the motor operates correctly before securing everything back in place.


Where is the interior fuse panel located on a 2007 Chrysler PT Cruiser?

There is no interior fuse panel. The panel is in the engine compartment behind the airfilter


How do you remove rear door panel on a 2007 Ford Escape?

how do you remove door panel on 2007 ford escape


Where is the interior fuse box for a 2007 dodge avenger?

The interior fuse box for a 2007 Dodge Avenger is located on the driver's side of the vehicle. You can find it by opening the driver's side door and looking for a small access panel on the side of the dashboard, near the steering column. Remove the panel to access the fuses inside.


What size wrench does a 2007 Sebring use to remove the oil plug?

13mm


Where are wiper fuses on a E200 2007 merc?

remove interior panel on the left driver side refer to users manual but there should be a second fuse box in the trunk on the left side, note a panel.


How do you remove the center console from a 2007 Chrysler Sebring?

The center counsel on a 2007 Chrysler Sebring can be removed by loosening the bolts on the bottom of the Council. The bolts are located at the back of the Council.


How do you fix the power window in my Chrysler sebring 2007?

The most common window problems in a 2007 Sebring are the fuse, the relay, the switch, and the motor. Check the fuse and the relay. If they are ok then the door will have to have the panel removed to reach the switch and motor.


Can you show me how to pop off the panel to remove the radio in the 2007 dodge ram?

can youi show me how to pop off the panel to remove the radio in the 2007 dodge ram.