0
Drain antifreeze. Jack Passenger side of car up. remove wheel well skirt. loosen pulley bolts on water pump before removing serpentine belt. loosen a/c compressor and slide forward about an inch. remove pulley from water pump. remove 4 bolts holding water pump in. remove water pump. reverse sequence to put new in.
What else can I help you with?
What is the labor cost to replace time change belt on a Ford Contour 1999?
what would it could to replace time belt on a Ford Contour 1999?
How do you replace the water pump on a 1999 Chevy Metro 3 Cy?
Remove the belt from your 1999 Chevy Metro water pump. Remove the water pump return hose. Remove the water pump retaining bolts. Reverse the process to replace the water pump.
How do you replace the power steering hoses in a 1999 Ford Contour 2.5 V6?
How to replace power steering hose in 1999 ford excort
How do you replace the intake plenum gasket on a 1999 Ford Contour?
very carefully
When should you replace your timing belt on your 1999 Contour?
Ford recommends 60K
How do you replace an alternator on a 1999 Ford Contour se v6?
You go to a mechanic.
How do you replace license plate bulb on 1999 ford contour?
you buy a new one
How do you replace the radiator on a 1999 Pontiac Montana?
Drain the water from the radiator. Remove the water hoses. Remove the retaining bolts. Reverse the process to install the new radiator.
What are the steps to replace the water pump in a 1999 GMC Jimmy?
Begin by draining the water from your 1999 GMC Jimmy cooling system. Next, remove the belt from your water pump. Third, remove the water return hose. Last, remove the water pump retaining bolts. Reverse the process to install your new water pump.
Where is the oil filter on a 1999 Ford Contour?
where is the oil filter on a ford contour, 1999
How do you replace heater fan in 1999 ford contour?
To replace the heater fan in a 1999 Ford Contour, first disconnect the negative battery cable for safety. Remove the glove compartment to access the fan assembly, then disconnect the wiring harness and remove the screws or bolts securing the fan. Carefully pull the old fan out, install the new fan in reverse order, and reconnect the wiring before reassembling the glove compartment. Finally, reconnect the battery cable and test the fan to ensure it operates correctly.
How do you replace the water pump on a 1999 Honda Accord LX 4 cylinder?
REMOVE THE TIMING BELT IS NUMBER 1.
