you buy a new one
How do you change the liscence plate light fuse
what would it could to replace time belt on a Ford Contour 1999?
To replace the license plate light on a 1999 Volvo S80, first, locate the light assembly at the rear of the vehicle above the license plate. Use a flathead screwdriver to gently pry off the lens cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and reattach the lens cover. Finally, test the light to ensure it works properly.
how do you change the rear license plate light on a 1999 Buick Regal
To replace the license plate bulb on a 1999 Cadillac Seville STS, start by opening the trunk and locating the license plate light assembly. Carefully pry off the lens cover using a flat screwdriver or a similar tool. Remove the old bulb by twisting it counterclockwise, then insert the new bulb by twisting it clockwise until secure. Finally, replace the lens cover and ensure it snaps back into place.
To replace the license plate bulb on a 1999 Ford Taurus, start by opening the trunk and locating the light assembly. Use a flathead screwdriver to gently pry off the plastic cover or lens. Remove the old bulb by twisting it counterclockwise and replace it with a new bulb by pushing it in and turning it clockwise. Finally, reattach the cover and close the trunk.
How to replace power steering hose in 1999 ford excort
very carefully
Ford recommends 60K
You go to a mechanic.
I have a 94 not sure if they are the same but behind the license plate was mine Good luck Answer Improvement (Sept 5. 2010) Remove 4 license plate screws and licence plate Remove 4 hex head screws that hold the license plate/backup light assembly Rotate the license plate/backup light assembly around 180 degrees so you can get to the light bulb holders Carefully turn bulb holders 1/4 and remove bulb holder Carefully remove old bulb and replace with new bulb (#194) Reverse these step to reassemble
To change the license plate light on a 1999 Lincoln Town Car, first, open the trunk and locate the license plate light assembly. Remove the screws or clips holding the light assembly in place, then gently pull it out. Disconnect the old bulb by twisting it counterclockwise, replace it with a new bulb, and reassemble the light assembly by reversing the removal steps. Finally, test the new bulb to ensure it works properly.