Open the hood and at the left and right side of where the hood latches there are plastic doors. Open one and look down into it. You should be able to see the back side of the wires and socket entering the headlamp assembly. Turn the light and pull it out. Its good to replace them both at the same time. If one burns out the other will soon follow, usually at the most inconvenient time. You can save the old still working light as a spare.
To replace the headlamp on a 1994 Jaguar XJS, first, open the hood and locate the headlamp assembly. Disconnect the electrical connector by pulling it off the back of the headlamp. Remove the retaining screws or clips holding the headlamp in place, then carefully pull the headlamp out of the assembly. Insert the new headlamp, secure it with the screws or clips, and reconnect the electrical connector before closing the hood.
Remove the outer plastic trim to reveal the lamp frame holding screws. remove the frame and the lamp comes out the front
for a 1994 Grand Caravan (probably like the 1995) see: How do you replace the headlight assembly located on a 1994 Dodge Caravan? for a 1994 Grand Caravan (probably like the 1995) see: How do you replace the headlight assembly located on a 1994 Dodge Caravan?
how do i change a fuel filter in a 1994 ford explorer
how do you replace the overdrive sensor on a 94 ford explorer
To change the headlamp bulb on a 1994 Concorde, first, ensure the vehicle is turned off and disconnect the battery for safety. Open the hood and locate the headlamp assembly; you may need to remove screws or clips holding it in place. Carefully pull the headlamp assembly out and disconnect the wiring harness. Finally, remove the old bulb by twisting it counterclockwise, replace it with a new bulb, reassemble everything, and reconnect the battery.
Lift the car on a jack, remove the tire, remove the brake shoe/caliper and remove the brake pad. Put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car.
Answering "How do you remove and replace the radiator in a 1994 ford F-150?"
The 1994 Ford Explorer rear bumper is held in place with eight retaining bolts. Remove the retaining bolts and the rear bumper will come off.
I believe there is no relay in the 94 YJ.... the power is regulated throught the switch.
a)For driver side. Just remove Power steering oil container (plastic) from fixer. b)For copilot side. Remove resonator pipes 2)Remove headlamp connector 3)Remove rubber gasket 4)Unhook bulb clamp to replace 5)Install in order inverse.
It is necessary to state whether it is a 4X4 or a 4X2