If it's like the 2005 Excursion, just peel back the arm rest cover where it swivels and there's one screw holding the whole assembly in.
with a socket wrench
Yes.
You can view the 2001 Ford Excursion owners manual online at : www . motorcraft service . com ( no spaces ) Click on Owner Information
In the 2001 Ford Excursion the V10 is rated at 310 horsepower
inside the door latch itself
To remove the rear bumper from a 2001 Ford Excursion, start by disconnecting the negative battery cable for safety. Next, locate and remove the bolts securing the bumper to the frame, which are usually found on the sides and underneath the bumper. You may also need to detach any wiring harnesses for lights or sensors. Once all fasteners are removed, carefully slide the bumper off the mounting brackets.
To remove the armrest on a Ford Ranger XLT, start by locating the screws or bolts securing it, typically found under the armrest or at the base. Use a screwdriver or socket wrench to remove these fasteners. Once removed, gently pull the armrest away from the seat, taking care not to damage any clips or wiring if applicable. Finally, ensure all components are safely stored or replaced as needed.
I have a 2000 Contour and there was a 19mm stud between the armrest and seat. It is hard to see and get the wrench on.
6 quarts
No. The tank must be dropped.
According to the 2001 Ford Excursion owners manual : With engine oil filter change : ( 6.0 quarts of engine oil ) for the 6.8 liter V10 gasoline engine
Behind the dash below and to the left of the steering wheel . Turn the ( 4 ) cover panel " pins ' counterclockwise to remove the cover panel