0
What else can I help you with?
Where is coolant fan sensor 1988 dodge dynasty?
The 1988 Dodge Dynasty coolant fan sensor is located a few inches above the thermostat housing. The thermostat housing can be found on the front of the engine.
Where is the cooling fan sensor on a 1999 Dodge Caravan?
The engine coolant temperature sensor is the two wire sensor near where the upper radiator hose attaches to the engine.
How do you remove the engine cooling fan assembly from a 2000 Dodge Intrepid?
http://wiki.answers.com/Q/How_do_you_remove_the_engine_cooling_fan_assembly_from_a_2000_dodge_intrepid"
On a 1999 Dodge Caravan why would the fan for the engine constantly keep running?
Air conditioner or defroster on - normal should be running Vehicle low on coolant? Trying to keep engine in normal range Defective coolant sensor?
What does the fan do in a car engine?
cools the engine. without a fan, the car will overheat and the coolant will boil. the fan controls this from happening by cooling the coolant as it passes through the radiator.
How do you get the fan off a duramax?
To remove the fan from a Duramax engine, first, disconnect the battery and drain the coolant. Next, unbolt the fan shroud and remove it to access the fan. Use a suitable fan clutch tool to loosen and remove the fan clutch from the water pump. Finally, carefully pull the fan off the clutch and set it aside.
How do you remove fan from 2004 Chevy Colorado?
To remove the fan from a 2004 Chevy Colorado, first ensure the engine is off and cool. Disconnect the negative battery cable, then remove the fan shroud by unbolting it from the radiator. Next, disconnect the fan's electrical connector and remove the fan clutch bolts using a wrench, allowing you to lift the fan out of the engine compartment. Be cautious of any remaining coolant and handle all components carefully.
What is the main cause for dodge caravan overheating when driving slowly in traffic?
Low coolant or an inoperative radiator fan.Low coolant or an inoperative radiator fan.
How do you remove fan blade on 2001 dodge ram 1500?
# Disconnect negative battery cable # Remove the serpentine drivebelt # Remove the coolant reservoir from the fan shroud and set it aside without draing the tank or disconnecting the hose # Disconnect the electrical connectors at the windshield washer reservoir and remove the reservoir from the fan shroud # Remove the fan shroud mounting bolts # A special 36mm fan wrench is required to remove the cooling fan can get at most auto parts stores
Why would the coolant fan stay running when the keys are out of the ignition in a 1998 dodge caravan?
The coolant fan is triggered by a temperature sensitive switch. when coolant reaches a certain temp it turns the fan on. When the coolant drops below that temp it shuts off the fan. The ignition switch plays no part in the operation of the cooling fan.
Why would the engine cooling fan on a 1998 Dodge Caravan stay on when engine is cool?
The fan is usually meant to cool the radiator. It shouldn't be anything to worry about. Since the radiator cools the antifreeze that has come from and circulates through the engine, as long as the fan is running, the coolant is remaining at a good temperature and you won't have to worry about overheating.
How Remove fan blade from 1999 Dodge 3.9 magnum?
The wench will be used to remove the clutch fan nut. Remove the nuts holding the fan then remove the fan blade.
