0
What else can I help you with?
Where is the crankshaft sensor located on a 1990 Oldsmobile cutlass ciera 2.5 l?
if its like my 87 olds ciera 4cyl its attached behind the ignition moduallType your answer here...
Where is the brake light switch located on a 1990 Cutlass Ciera?
The brake light switch is located on a bracket behind the brake pedal support.
How do you remove the blower motor and fan on a 1990 Cutlass Ciera?
The radiator fan motor is conected to the shroud by 4 -10 mm screws. remove them and lower fan motor bracket down to allow access to the electrical connection from the motor it is a press fit with a latch. With electrical disconnected lift up and out of the engine compartment. After it is out there are three screws holding motor to bracket. The fan blade is attached by one nut -left hand thread.
How difficult is it to replace the thermostat on a 1990 Cutlass Ciera with a 3300 engine?
It is quite easy to change the thermostat in your 1990 Cutlass. Remove the thermostat housing retaining bolts. Remove the thermostat from the housing. Reverse the process to install the new thermostat.
What is the weight of a 1990 bayliner ciera 2655?
What is the weight of a 1990 bayliner 2655 sunbridge
Does the 1990 Oldsmobile cutlass Ciera have an ABS?
no it has dic brakes
Where are the fuses located for 1990 cutlass ciera?
GLove box
What is the weight of a 1990 cutlass ciera?
Around 3,000 lbs
Can doors from a 1990 Olds Cutlass Ciera sedan be used to replace the doors on a 1990 Olds Cutlass Ciera station wagon?
yes, most of the panels can be used from one to the other
How do you change the brake pads on a 1990 Oldsmobile cutlass ciera?
FRONT OR REAR ?
Where is the computer located on a 1990 olds cutlass ciera?
Remove the RH lower dashboard sound insulator and the glove compartment. Look for a shiny metal box about the size of an old GM ECM.
Where is the cam sensor for a 1990 Oldsmobile cutlass ciera?
i have a 90 cutlass ciera with a v6 3300 and just replased that. it is called a combanation sensor. its the crankshaft and cam together located at the back of the harmonic balancer attached to the block. it has 2 bolts on the right side holding it to the block a one in the middle to hold the sensor in place and the sensor sits in it and faces the harmonic balancer on the back of the interrupter rings
