remove the top dash panel closest to the windshield, then remove mounting screws for dash module.
To remove the dash bezel on a 2001 Jeep Wrangler, start by disconnecting the negative battery cable for safety. Use a flathead screwdriver to gently pry off the trim surrounding the bezel, then remove any screws securing the bezel in place. Carefully pull the bezel away from the dashboard, disconnect any electrical connectors for components like the hazard switch, and then fully detach it from the vehicle.
Remove the dash bezel, remove the switch, reverse process with new switch.
The panel for the heater under wind screen just clips in remove the panel and you will be able to remove the center bezel.
To remove the dash bezel on a 2004 Monte Carlo SS, start by disconnecting the negative battery terminal to ensure safety. Next, carefully pry off the trim surrounding the bezel using a trim removal tool to avoid damage. Once the trim is removed, locate and unscrew any screws securing the dash bezel in place, then gently pull it away from the dashboard to detach it. Be cautious of any electrical connections, and disconnect them if necessary before fully removing the bezel.
there are two nuts on the bezel behind the dash. you can reach them from underneath.
I am pretty sure you have the toggle style switch, remove the lower dash bezel, and the switch is connected to the metal frame with 2 screws.
You have to remove the vent & bezel assembly from below the radio first, then the entire dash bezel from around the instrument cluster & radio.
the dash bezel is held in place with clips. you will need to carefully pull or pry the bezel loose and work your way around it.
pop out/up the vent cover that is below the windshield and is the width of the dash. a flat head screwdriver works well to get under the vent cover. once out, you'll easily identify the screws retaining it.
my3mp
I just did this. You can simply use a butter knife to GENTLY wiggle the bezel from it's fixture. Try inserting the knife near the crease points on the dash.
You have to remove the vent & bezel assembly from below the radio first, then the entire dash bezel from around the instrument cluster & radio.