To remove the dash bezel on a 2001 Jeep Wrangler, start by disconnecting the negative battery cable for safety. Use a flathead screwdriver to gently pry off the trim surrounding the bezel, then remove any screws securing the bezel in place. Carefully pull the bezel away from the dashboard, disconnect any electrical connectors for components like the hazard switch, and then fully detach it from the vehicle.
The panel for the heater under wind screen just clips in remove the panel and you will be able to remove the center bezel.
remove the top dash panel closest to the windshield, then remove mounting screws for dash module.
There is a narrow filler strip along the windshield at the top of the dashboard. Pull that out (it is held in with friction tabs). This will expose two screws on the top of the center bezel. Remove the two screws and also there may be a screw at the bottom of the bezel behind the ash tray (if your jeep has one). Then the bezel should just pull out.
The 2001 Jeep Wrangler has 8 valves.
Where is the resistor on 2001 jeep wrangler
The 2001 Jeep Wrangler has overhead valves (OHV).
The 2001 Jeep Wrangler is a gas-powered vehicle.
The 2001 Jeep Wrangler has an inline 4 engine.
The 2001 Jeep Wrangler has a 5-speed manual.
how do you remove the doors from a 2004 jeep wrangler
NO
The height of the 2001 Jeep Wrangler is 5 ft. 11.1 in. (71.1 in.).