To remove the dash speakers in a 2009 Chrysler 300, first, disconnect the battery to ensure safety. Next, carefully pry off the speaker grille using a flathead screwdriver or a trim removal tool to avoid damaging the dashboard. Once the grille is removed, unscrew the speakers from their mounting, and gently disconnect the wiring harness. Finally, pull the speakers out and replace them as needed.
To remove the dash speakers in a 1996 Chrysler Town and Country, first, disconnect the vehicle's battery to ensure safety. Then, carefully pry off the speaker grille using a flat tool to avoid damaging the dashboard. Once the grille is removed, unscrew the speakers from their mounting brackets and disconnect the wiring harness. Finally, remove the speakers from the dash.
3.5 in the top dash for Chrysler 300
Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.
3.5"
just remove the grills off the speakers with a flat head screw driver
Remove the dash pad, then remove the speakers from the dash frame. For the rear speakers, open the trunk and remove the brackets, that hold the speakers in place. not for the back speakers ..you have to remove the lower rear seat then remove the seat belts then the rear seat back then remove the header panels in the back seat then remove the deck cover ..the rear speakers are bolted in from the top down under the rear deck cover....and the front speakers i believe are mounted in the door panels in the front doors ..you have to remove the door panels to remove them .some do have them in the dash also if they are there u do as the person stated before me.
In order to remove the speakers, you must remove the "Dash Pad". It's held in place with clips and a couple screws. Start by pushing up in the center of the dash pad. Then remove the screws.
remove the grills connect two 3 1/2's (the left will fit VERY TIGHT) but it replaced cardboard and wired into pre made slots for the speakers very easy in the end.
with my 91 SE its...remove the one screw holding the dash on which is located in the glove box then pop the top dash assemble off.In order to remove the speakers, you must remove the "Dash Pad". It's held in place with clips and a couple screws. Start by pushing up in the center of the dash pad. Then remove the screws.
It is under the dash, you have to remove entire dash to access.
Remove the whole front panel, and get a manual on how to re-do the whole dash interior.
No need. The speakers come out the top of the dash.