I would recomend purchsing a shop manual for that truck. It would give you step by step directions to remove the dash assembly. It will be a time consuming job. Good luck.
aua cuz
remove dashboard and replace 2 bulbs behind it
The 1998 Ford Taurus dashboard is held in place with 12 retaining clips. Pry outward on each retaining clip. The dashboard will come off.
Do not get involved take it to a garage they are a piece.
You'll have to remove the driveshaft first.
To change the starter on a 1998 s10, the motor mount will have to be removed. Support the motor on a jack with a board on the top of it, and remove the mount to get to the starter.
You can find one at a Chevy parts dealership, or you can find a less expensive one at your local junk yard.
How do I remove the dashboard.
To remove the dashboard from a 1998 CLK Mercedes Benz, start by disconnecting the car battery for safety. Next, remove the trim pieces surrounding the dashboard, which may involve unscrewing or prying them off. Then, detach any screws or bolts securing the dashboard, including those near the instrument cluster and the air vents. Finally, carefully pull the dashboard away from the frame, taking care to disconnect any electrical connectors for the gauges and controls.
To replace the ABS bulb in the dashboard of a 1998 Volvo S70, first, disconnect the car battery to ensure safety. Remove the dashboard panel by unscrewing any screws and gently prying it off. Locate the ABS bulb holder on the back of the dashboard, twist it counterclockwise to remove the old bulb, and insert the new bulb. Finally, reassemble the dashboard and reconnect the battery.
To remove the door of a 1998 S10, start by disconnecting the battery to prevent any electrical issues. Next, remove the door panel by taking off screws and clips, then disconnect any wiring harnesses. Support the door with a jack or have a helper hold it, then remove the hinges by unscrewing the bolts. Finally, lift the door off the hinges and set it aside.
Begin by removing the dashboard speaker covers on your 1989 Chevy S 10 Blazer. Remove the speaker retaining screws. Remove the speaker wiring harness. The speakers will come out.