take a pry bar and stick it in where the seat tilts on the drivers side and tilt the seat half way gently pry between the seat and rear plastic side panel to release the retaining pin you may have to move it back and forth a bit because it only realeses in one spot once you have the drivers side out you must do the same for the passengers side .
when you remove the back seats on a 2000 Pontiac grand am SE if you look threw the trunk there will be a string that you pull that will fold the seats down and at the bottom there will be two latches to remove seats
Yes, the back seats in a 2004 Sunfire do fold down. There are straps on the back of the seats that are used to pull the seats down. The straps are assessable through the trunk of the car.
How do you let down the back seat in Pontiac g6 Gt
if you havent figured it out yet. you have to go into the trunk. then inside the truck you will see two "loops" at the roof of your trunk. you pull them and push the seat forward. i hope that helped.
Spring faces down toward engine.
at the water pump remove the heat shield over the exhaust manifold and look down and you will see 2 bolts n the housing remove thease and replace the thrmosstat
To fold down the seats through the trunk in a 2000 Pontiac Sunfire, first, open the trunk lid and locate the release straps or levers on the back of the rear seats. Pull the straps or levers to release the seatbacks. Once released, push the seatbacks forward to fold them down flat, providing additional storage space. Ensure that the seats are securely locked back in place when returned to their upright position.
check down under the steering wheel at the bottom of the dash
when it is worm you got to keep the throttle down to start
To remove the rear seats from a 2009 Pontiac Vibe, start by folding down the seatbacks for easier access. Locate the bolts or screws at the base of the seat cushions; these may be covered by plastic caps that you can pry off. Use a socket wrench to remove the bolts, then lift the seat cushions out. For the seatbacks, there may also be bolts at the bottom or clips that need to be disengaged before you can remove them completely.
is there a emergency switch that shuts the fuel pump down
is the floor wet under the seats??? if the sir (air bag module) get wet and and crusty....it drags down the uart data line.....(the line that all the computers talk to each other)to ground.....look at that