on the drivers side of your truck right behind the front tire the front drive shaft attaches to the front differential yoke. There is 4 small torx head screws (bolts) holding the drive shaft to the yoke. Remove these 4 bolts and take out the u bolts that hold on the U-joint put a large screwdriver or something between the u-joint and pry and it should pop loose. There is very little space but the drive shaft has to go out forward under the front differential and the yoke going into the Transfer case may need a little help coming out. Again the large screwdriver may help if it doesn't slip right out. Putting it back is the exact reverse. If your gonna leave it out and drive it cover the hole into the transfer case to avoid dirt and debris clogging it up and making putting the yoke back in a real pain. Good luck.
Does anyone know how to remove the chrome part of the front bumper on a Ford Ranger XLT
To change the front U-joint on a 2002 Ford Ranger, first, lift the vehicle and secure it on jack stands. Remove the driveshaft by unbolting it from the differential and the transmission, then take it out. Use a U-joint press or a hammer to remove the old U-joint from the driveshaft, and then insert the new U-joint, ensuring it's properly aligned. Finally, reassemble the driveshaft and secure it with the bolts, making sure everything is tightened to the manufacturer's specifications.
no
is it front or rear
where is the driveshaft on a 2005 Ford Ranger
if the play is in driveshaft, replace u joints. if the play is actually in the diff, remove driveshaft and tighten pinion bearing.
It takes a cutting torch.
"http://wiki.answers.com/Q/How_do_you_remove_Front_Rotors_on_a_1994_ford_ranger"
How do your remove the dashboard on a 2000 Ford Ranger?
How do you remove the flywheel on a 1999 ford ranger
Remove your front axles.
are there struts or shocks on the front of a 1994 ford ranger 2wd