98 chevy s10
Remove 2 small u-bolts from rear end yoke Pry drive shaft out of yoke Slide front end of drive shaft off front splines
well a cranks shaft u need a hand to pump its the same as petrol because when u pump it A WIERD SUBSTANCES EJACULATES FROM IT :)
we can drive shaft run out thriugh the dail indicator. 1. put the dail indicator at shaft 2.checking 3.marking at 4 section. 0 , 90 ,180 ,270 4.chek clearance 5.check bearing surface 6.check earw ring check shaft cracking
replace tail shaft seal. to do this, remove drive shaft first. It helps if the front of the car is pointed down a steep hill. This way you won't loose any trans fluid.
A drive shaft allows torque to enter a motor. Louis Renault of France was the inventor of the drive shaft. He invented the drive shaft in 1898.
is the drive shaft the same as the intermediate shaft on a vauxhall corsa car does any body no
The drive shaft is part of the drive train, not part of the transmission.
Yes Drive Shaft is a real band.
F150 4x4 drive shaft balanced
tool for drive shaft
The drive shaft connects the transmission to the differential.
there is no drive shaft it's front wheel drive
there is no dry shaft oly a crankshaft in the engine and the drive shaft that moves the car the drive shaft is connected to the transmission and the rear axle if your car is front wheel drive ypu do not have a drive shaft just a transmission and two axles
this requires a drive shaft company that can cut and weld it and balance it after.
Chock the wheels to be sure vehicle will not roll. Mark the differential and drive shaft before removing drive shaft. Remove 4 bolts from differential-end of drive shaft. Place a pan under the transmission-end of drive shaft and have clean rags handy. Push the drive shaft slightly toward the front of the vehicle while pulling downward on the drive shaft and lower it to the ground. Pull the drive shaft toward the rear of the vehicle until the front of the drive shaft pulls out of the transmission. Place the drive shaft on the ground and put rags in the transmission to prevent oil leakage and keep dust/dirt out. Assemply is reverse of removal with special attention to aligning marks on the drive shaft to the mark on the differential.
how to remove a drive shaft on a fiat doblo