how do i remove the front fender to 1996 Oldsmobile cutlas supreme.
Take it to Best Buy and have them switch out the speakers. That's what I did.
Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
In front of the passenger side front tire. Remove the fender liner to access.In front of the passenger side front tire. Remove the fender liner to access.
Inside the left front fender, remove the inner plastic fender liner to access.Inside the left front fender, remove the inner plastic fender liner to access.
It is under the left front fender, remove the plastic liner in front of the tire to access.It is under the left front fender, remove the plastic liner in front of the tire to access.
To install front brakes on a 1988 Cutlass Supreme, first, lift the front of the vehicle and remove the wheel. Next, remove the caliper by unbolting it from the bracket and slide it off the rotor. Replace the old brake pads with new ones, ensuring they are properly seated, then reattach the caliper and bolt it securely. Finally, reassemble the wheel, lower the vehicle, and pump the brakes to seat the pads.
which fender frontor rear front
Should be the "peel off" type Remove wheel Remove caliper mounting bolts Slide caliper off rotor Rotor should slid off hub
I have 2 of these cieras and NO they are front wheel drive, the cutlass supreme is real wheel drive
I have a 1982 cutlass supreme and the diagram in under the hood on a front panel, If not someone may have removed it.
first you pull off the the cowl panel and there will be a bolt under it and three on top of the fender. Then remove the front grill {there is four sctews on top of it}. There will be one or two bolts in front. then there is a bolt or two when you open the door you shoule be able to see them. then there is a bolt on the bottom of the fender at the back. Then remove the in fender bolts connecting it to the fender.
Front = 3 & half, Rear = 4x10