pull out the speaker covers, get a 7mm socket, & remove the 2 screws..
Speaker grilles are held in with a combination of velcro tabs and clips. The grilles just pull out toward you. You can pry on them a little from the bottom edge to get it started. Just press them back into place to reinstall.
pull speaker grilles up and toward front of car then then they come off and you can get to the speaker screws.
To replace the factory speakers on a 1970 Buick Electra 225 Convertible, first remove the speaker grilles and any mounting screws or clips securing the old speakers. Disconnect the wiring harness from the back of each speaker, then carefully remove the old speakers from their mounts. Install the new speakers by connecting them to the wiring harness and securing them in place with screws or clips. Finally, replace the speaker grilles to complete the installation.
The 1990 Chevy Corvette front drivers side speaker cover will need to be removed. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
To remove a magnet in a speaker, first detach the grill in the front of the speaker, second unscrew the speaker after that remove the speaker from the cabinet and cut the speaker cone. Lastly, gently discard the magnet from the speaker cone.
The speaker covers are held in with a screw, remove it and tilt it out away from where the screw was. then remove the screws holding the speaker in and remove the speaker.
The 1992 Chevy Corvette front speaker covers are held in place with two retaining screws. Remove the retaining screws and the speaker covers will come off.
1.Remove the front door trim panel.Remove the speaker retaining bolts.Disconnect the electrical connector and remove the speaker from vehicle. Installation is the reverse.
Remove the speaker covers, by loosening the retaining screws. Remove the speaker retaining screws. Remove the wiring harness. The speakers will come out.
You have to remove the whole dashboard and then the speaker should be exposed, then just remove it.
You will need to remove the front speaker covers. The speaker covers are held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install your new speakers.