reach up under the dashboard by the light switch, feel around on the top of the switch for a small metal "button" about 1/4" in diameter. You have to depress this while pulling out on the knob from the front of the dash. It sometimes sticks so you have to "play" with it (move it in and out while holding down the button) and it will come out. The shaft is triangular in shape and can go back in any orientation, you just push it in until it "snaps" into place and you can not pull it out again.
Rotate the headlight switch knob left or right with headlights turned on.
how to remove the knob of the windshield wiper control there is a slot at the end of the knob close to the dash.Use an angled pliers or bend a wire or paper clip and insert it between the knob and rod towards you to loosen it
Unscrew bezel and switch should slide out through the rear (under dash)
The gear shift knob on a ford Ranger is pressed on tightly. A heat gun or hair dryer can be used to heat the knob to help remove it.
Disconnect the battery. With one hand behind the dash and on the bottom of the switch you will feel a little spring loaded button. Pull the knob out and press the button and the knob will come out of the switch. Remove the wiring connecter and reverse the procedure.
You have to reach up behind the dash and push a small spring loaded button on the headlight switch, then the knob and shaft will pull out as one.
Salvage yard or dealer.
Is it the "pull out" knob type? If so, there is a little silver button on the rear side of the switch. Depress this button and pull the knob all the way out of the switch Then unscrew the bezel to remove aswitch from the rear Ford recommends replacing the connector also.
To remove the headlight switch knob from a 1994 Dodge B250 full-size van, first, pull the knob out to the "on" position. Then, look for a small release tab or pin on the side of the switch shaft; press it in while simultaneously pulling the knob straight out. If the knob does not come off easily, check for a set screw that may need to be loosened. Once the knob is removed, you can proceed to replace the headlight switch.
The Knob is threaded , Just unscrew it by hand
To remove the headlight switch on a 1966 Ford F-100, first disconnect the negative battery cable to ensure safety. Then, remove the dashboard panel to access the switch. You will need to pull out the switch knob and shaft, which can be done by pressing the release button on the switch. Finally, unscrew the retaining nut and disconnect the wiring harness to fully remove the switch.
puch the knob on the headlight switch in, then turn it clockwise about a quarter inch, then pull it out. Its actually very easy.