I use wd forty spray.Just spray on,work in with finger then scrape with razor.After getting it all off you can use a soapy dish cloth to remove the WD40 residue,then windex.
To remove the mounting button from the rearview mirror on a 1996 Buick Park Avenue, first, you should ensure that the vehicle is turned off and the mirror is in a safe position. Locate the set screw or retaining clip that holds the mirror to the mounting button; this is typically found on the underside of the mirror arm. Use a small screwdriver or Allen wrench to loosen or remove the screw, and then gently slide the mirror off the mounting button. If the button itself is stuck, you may need to gently twist or wiggle it to free it from its position.
The small plastic cover in the corner of the window is removable. Mirror mounting fasteners and wiring connections can be removed to remove mirror.
* Remove the door trim panel * On power mirrors unplug the electrical connector * Remove the triangler cover over the mirror mounting * Remove the bolts and detach the mirror from the door
Unscrew the three mounting screws on the underside of the mirror assembly.
(1)Remove the door trim panel; (2)disconnect the electrical connector for the power mirror (3) where necessary, lower the window for access to the mirror mounting nuts (4)remove the mounting nuts and take the mirror out. - Haynes Ford Ranger Pickups Repair manual
To remove the rearview mirror on a 2000 BMW M5, first, locate the mounting bracket that secures the mirror to the windshield. Use a flathead screwdriver to gently pry off any plastic cover concealing the mounting screws. Once exposed, unscrew the mounting screws or loosen the set screw, then carefully slide the mirror off the bracket. Make sure to handle the mirror gently to avoid damaging the windshield.
* Remove the door trim panel * On power mirrors unplug the electrical connector * Remove the triangular cover over the mirror mounting * Remove the bolts and detach the mirror from the door * Installation is the reverse of removal
* Remove the door trim panel * On power mirrors unplug the electrical connector * Remove the triangular cover over the mirror mounting * Remove the bolts and detach the mirror from the door * Installation is the reverse of removal
To remove the rear view mirror off a 2000 Mitsubishi Mirage first pop off the plastic cover place on the body of the mirror. Than proceed to unscrew the mounting screws.
To replace the mirror on a 2004 Endeavor, first, carefully remove the interior door panel to access the mirror's mounting bolts. Disconnect the electrical connector if the mirror is powered. Unscrew the old mirror from the door, then attach the new mirror by aligning it with the mounting holes and securing it with screws. Finally, reattach the door panel and reconnect any electrical components.
To remove the rearview mirror from a 2005 Scion xA, start by locating the mounting bracket at the base of the mirror. Use a small screwdriver to loosen the set screw on the bracket, typically found at the front or side. Once the screw is loosened, gently slide the mirror off the mounting bracket. If the mirror has any wiring for features like auto-dimming, carefully disconnect it before fully removing the mirror.
The passenger side mirror on a 2001 Toyota Sienna is mounted by screws. To replace the mirror remove the mounting screws and unplug the wire clip.