0
To remove the ignition system from a 1988 Plymouth Reliant, first disconnect the negative battery cable to prevent electrical shock. Next, remove the ignition coil by disconnecting the wiring harness and unbolting it from its bracket. Then, access the distributor by removing the air cleaner and any obstructing components, disconnect the vacuum advance, and unbolt the distributor from the engine. Finally, lift the distributor out carefully, ensuring any attached components are also removed.
What else can I help you with?
How long is the oil dip stick in a 1988 Plymouth reliant?
About 18 inches
How do you remove the radio from a 1988 Plymouth reliant?
remove all of the screws holding on the wood grain pane wrapped around the steering wheel and radio then remove two bolts holding the radio in an there ya go
How do you install a camshaft seal in a 1988 Plymouth reliant 2.5l?
youtube that sh*t bro haha
Where is the power brake reservoir on a 1988 Plymouth Reliant?
Under the hood on the upper firewall on the driver's side
What is the gas tank capacity of a 1988 Plymouth reliant?
The gas tank capacity of a 1988 Plymouth Reliant is approximately 14.5 gallons. This model was designed to be economical, reflecting the compact car trends of the late 1980s. Its fuel efficiency, combined with the tank size, contributed to its practicality for daily driving.
Where is the knock sensor on a 1988 Plymouth reliant?
On a 1988 Plymouth Reliant, the knock sensor is typically located on the engine block, near the cylinder head. It is usually found on the lower part of the engine, often on the driver's side. To access it, you may need to remove certain components for better visibility. If you're having trouble locating it, consulting a repair manual or a service guide for the specific engine type can be helpful.
Where is the oxygen sensor located on a 1988 Plymouth reliant?
There are two. They are in the exhaust system. One is before and one is after the catalytic converter.
How do you remove the ignition module on a 1988 ford f-250?
how do you remove the ignition control module on a 1988 ford f-250 pickup?
Will a 1988 dodge mini ram van cvc fit a 1983 Plymouth reliant?
no it wont cause the engine mountings are different
How do you replace speedometer cable on 1988 Plymouth reliant le?
To replace the speedometer cable on a 1988 Plymouth Reliant LE, first, disconnect the negative battery terminal for safety. Remove the instrument cluster by unscrewing the bolts and carefully pulling it out. Detach the old speedometer cable from the back of the cluster and the transmission, then install the new cable by reversing the process, ensuring it is securely connected at both ends. Reassemble the dashboard and reconnect the battery to complete the installation.
How do you remove the ignition switch in a 1988 Isuzu pickup?
how to remove lock cyliner switch 1988 Isuzu pickup
Where is the starter on a 1988 Plymouth reliant k?
It is on the back of the engine, under the intake.It is on the back of the engine, under the intake.
