0
the electrical one or the key side? remove the steering column cover from around the column put the key in the ignition turn it to run which is right before start.under neath the lock assembly in the middle is a small fin looking button push it up with a small screwdriver and slide the lock cylinder out .It will ONLY come out or go in with the key in the run position.the electrical switch is on the opposite side of the column unplug it after lock cylinder is out and unscrew it pop it out
What else can I help you with?
How do you unlock the ignition switch on a 2003 dodge neon?
How do i unlock my ignition switch on 2003 dodge neon sometime it does it some times it doesn't but now it wouldn't unlock
How to Remove ignition switch from Nissan?
how to change a ignition switch on a nissan altima 2003
Where is ignition coil 3 located on a 2003 dodge ram?
The ignition coil should be inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
Where is the cut off switch for the fuel pump in a 2003 dodge durango?
There is no inertia switch on a Dodge.
How do you replace the ignition of a 2003 opel corsa 1.6 sport?
To replace the ignition on a 2003 Opel Corsa 1.6 Sport, first, disconnect the battery to ensure safety. Remove the steering column covers to access the ignition switch, then detach the switch by unscrewing it and disconnecting the wiring harness. Install the new ignition switch by reversing the steps, ensuring all connections are secure, and finally, reconnect the battery to test the new ignition.
How do you replace an ignition switch on a 2003 Honda element?
To replace the ignition switch on a 2003 Honda Element, first disconnect the negative battery terminal to prevent electrical shorts. Remove the steering column covers by unscrewing them, then locate and detach the ignition switch, which is typically secured by screws. Disconnect the wiring harness from the old switch, install the new ignition switch, reconnect the wiring, and reassemble the steering column covers. Finally, reconnect the battery and test the new switch to ensure proper functionality.
What are the stages of failure on an ignition switch on a 2003 Chevrolet Malibu?
remove trim around switch ( it just pops off ) then remove the hold down bolts, push in at an angle a bit then pull it out. but unhook battery negative cable first ! then remove the connector for the wires.
How do you remove the ignition key cylinder from a 2003 Kia Optima when a key broke off in the cylinder?
You will need to remove the retaining ring at the top of your 2003 Kia ignition cylinder. The ignition cylinder will slide out. Remove the wiring harness from the back of the ignition cylinder.
How do you remove the clutch pedal switch on a 2003 Hyundai elantra?
To remove the clutch pedal switch on a 2003 Hyundai Elantra, first, ensure the vehicle is in gear and the ignition is off for safety. Locate the switch mounted on the clutch pedal assembly, typically near the top of the pedal. Disconnect the electrical connector by pressing the tab and pulling it off, then remove the switch by unscrewing it or twisting it counterclockwise, depending on the design. Finally, replace it with a new switch by reversing the steps.
Where is the fuel safety switch on a 2003 dodge diesel?
Dodge does not use inertia/ reset switches.
Is there an inertia switch located on a dodge intrepied 2003?
No, Dodge doesn't use inertia switches.
Is there a fuel pump reset switch for 2003 Dodge Caravan?
No, Dodge does not use inertia/reset switches.
