just pull out the fromt and unzip the back (1998 soft top)
to lower the top, no, they will fold up, but to avoid creasing the windows it is good to remove them first
undo the bolts from the side and remove top. its not hard
throw a rock at it
Remove it from Control Panel, side bar, add or remove Windows components.
It depends on if you have a factory soft top or after market (like Bestop). But they should be similar- remove the side & rear windows, then remove the canvas top & fold the frame. If it is factory, look for an owner's manual for your Jeep or look on manufacture's website for directions. I was able to download a user's manual for my Bestop from their site.
If you're talking about the rear side windows, you take the hardtop off. If you're talking about the front windows, you use the crank on the door. u don't. u take them off.
This is a broken wire in the driver side door. Remove the boot and you will see the broken wire. Spice wire and re-attached. All will work.
driver side on left side of dash/steering wheel - remove panel on side
With a Brick
Check out the web site toyotafiberglass.com they show how to remove them on there with pictures and directions.
Power windows were an option.
There is no circuit breaker. CHeck your fuse box relay (passenger side next to glve compartment)make sure no fuses are blown. Each window has its own relay circuit module. If one of the windows will not roll down or up, simply remove the relay (switch) and replace it. for starters, remove the door panel from driver side and passenger side. remove one of the (switches) that rolls the window up and down, and swap them out. that will test to see it its faulty or not. best thing to do is go to autozone or parts house and order it..they are cheap