answersLogoWhite

0

FIRST BLOCK THE REAR WHEELS SO IT DON'T ROLL WHEN YOU REMOVE THE DRIVESHAFT. Then take a screw driver and pop the rear seal out of the transmission tail shaft housing and then tap the new seal in with a hammer being carefull not to bend the seal.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you remove a 1946 Chevy transmission?

drop rear end out then you can slide out trans. ///remove the drive shaft disconnect transmission mounts unbolt the bell housing from the engine and pull transmission back and out if you only want to remove transmission remove the four bolts from the bell housing and pull out tranny


Where is the transfer case in a 2007 Chevy Suburban 1500 four wheel drive Lt?

It is bolted to the rear of the transmission. Both driveshafts connect to it.


Step by step how to install a transmission in a Chevy s10 6-cylinder 2.8 with 4 wheel drive?

To install a transmission in a Chevy S10 6-cylinder 2.8 with 4-wheel drive, start by safely lifting and securing the vehicle. Remove the driveshaft, shift linkage, and any electrical connections to the transmission. Unbolt the transmission from the engine and remove it from the vehicle. Position the new transmission, reattach it to the engine, reconnect the electrical components, driveshaft, and shift linkage, and finally, fill the transmission with the appropriate fluid before testing.


Where is the automatic transmission drain plug on a 2000 Chevy Blazer 4.3 rear wheel drive?

there is no drain plug on that transmission.you must remove the transmission oil pan and wile your there replace the filter.


How do you remove and replace the clutch cylinder on a 1999 Chevy s-10?

To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.


Will a 4 speed transmission from a 1988 Chevy 1500 2 wheel drive interchange with a 4 speed transmission from a 1988 Chevy 1500 4 wheel drive?

No, the rear section is different.


What do you have to change in a 1995 Chevy Suburban 4x4 to make it 2 wheel drive?

You will have to get a 4L60E 2-wheel drive transmission and put in it. You will also have to get a driveshaft made for it too. You will also have to remove the front driveshaft.


What causes 2004 Chevy half ton four wheel drive pickup Auto Transmission to slip in drive and not reverse?

a blown transmission


Where is the transmission control system located on a 1996 Chevy blazer?

where is the transmission control system on a 1996 chevy silverado 2 wheel drive 5.7


Where is the transmission mount on a Chevy 305?

It will be on the back of the transmission where the drive shaft goes in, and bolted to the cross member


Why is a 85 Chevy Celebrity not moving forward in drive?

Transmission Issues. Have it towedto a transmission shop and get it fixed.


How do you change out the rear main seal on a 2002 Chevy Tahoe 5.3lt?

You must remove the transmission and fly-wheel. then pry it out and drive the new 1 back in. Nothing to it.