with a mallet
1:remove interior passenger side door panel. 2:remove window motor and electrical conector 3:releas window from track by relieving proper bolt. 4:slide window out
To replace or remove the passenger side window on a 1995 Lebaron convertible, start by lowering the window fully. Remove the door panel by unscrewing any fasteners and carefully prying it away from the clips. Disconnect the window motor and any wiring, then remove the window glass by unscrewing the window regulator bolts. Carefully lift the window out of the track, and to install the new one, reverse the steps.
Remove the door panel then the motor. The window regulator is spring loaded and there are sharp edges inside the doors so be careful.
Begin by removing the 1994 Chevy passenger side door panel. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install the new window motor.
You will need to remove the inside door panel in your 1989 Ford Mustang. Remove the window retaining clips. The window will lift out. Reverse the process to install the new window.
Remove the window motor from regulator. This will free the window for movement.
To remove the passenger side window on a Ford Windstar, first, carefully detach the door panel by removing screws and clips. Once the panel is off, disconnect any electrical connectors and remove the vapor barrier if present. Then, locate the window regulator and disconnect it, ensuring the window is in the fully up position. Finally, gently push the window up and out of the frame, taking care not to damage any components.
There is only one fuse for all power windows. If only the passenger side window does not work, the problem is either with the passenger window switch or the motor on that window.
On most cars it just pries out of the door handle. Be careful not to break it.
remove from in side pushing out with pry bars and an smallrope pasents jental
To put a passenger side window back on track on a Ford Expedition you should first carefully remove any old silicone. Next put the window back on track, and use Gorilla glue or silicone to secure it. Do not put the window down for at least 24 hours.
Rear window relay is inside the pillar on drivers side - its easiest if you remove th rear passenger interior side panels