To remove the rear wiper arm on a 2007 Dodge Nitro, first, lift the wiper arm away from the rear window. Locate the small plastic cover at the base of the wiper arm and carefully pry it off to expose the nut underneath. Use a socket wrench to remove the nut, then gently wiggle and pull the wiper arm off the splined shaft. If necessary, a puller tool can be used to help loosen the arm if it’s stuck.
There are many places where a 2007 Dodge Nitro can be bought. A 2007 Dodge Nitro can be bought at popular on the web sources such as Auto Trader and Yahoo! Autos.
The fuel filter on a Dodge Nitro is part of the fuel pump module in the tank. You need to remove the fuel tank to access the pump.
The 2007 Dodge Nitro has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
The fuel filter on a Dodge Nitro is part of the pump module in the fuel tank.
How to
Fuse number for rear wiper dodge caliber 07
Chain
Dot 3
The heater resistor on a 2007 Dodge Nitro is typically located under the dashboard on the passenger side, near the blower motor. To access it, you may need to remove the lower dashboard panel. Once exposed, the resistor is usually mounted on the HVAC housing and can be identified by its electrical connector and multiple terminals.
it is part of the engine controller not a separate unit
19.5 gals. (approx.)
The 2001-2007 Dodge Caravan and Grand Caravan takes 28" replacement windshield wiper blades on both sides front and an 16" rear replacement wiper blade.