To remove the serpentine belt from a 2000 Mercury Sable, first, locate the belt tensioner and use a wrench or socket to rotate it counterclockwise, which will relieve tension on the belt. Carefully slide the belt off the pulleys, starting with the easiest one to access. Make a note of the belt routing or take a picture for reference when installing the new belt. Once the belt is removed, you can replace it as needed.
See "Related Questions" below for information about alternators and serpentine belts. Should be a good start to your project...
no it will not
mercury sable
To remove the water pump from a 2000 Mercury Sable, first ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then remove any components obstructing access, such as the serpentine belt and any brackets. Unbolt the water pump from the engine block and carefully pull it away, making sure to clean the mating surface before installing the new pump. Reassemble in reverse order, ensuring all connections are secure and leak-free.
The 2000 Mercury Sable starter can be found on the right hand side of the engine. The starter will be near the back of the engine.
The 2000 Mercury Sable starter will have three retaining bolts. There will be two cable retaining nuts on the front of the starter.
on the steer wheel
On a 2000 Mercury sable : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver
torque specs 2000 mercury sable 3.0 12V rod bolts
In a 2000 Mercury Sable : The thread on cap on the engine coolant reservoir is the pressure cap / radiator cap
There is a thermostat on all cars.
According to the 2000 Mercury Sable Owner Guide : ( Motorcraft MERCON - V , automatic transmission fluid in both types of automatic transaxle / transmission )