The 1994 Ford Probe has a brake fluid reservoir that should be mounted on the drivers side firewall. Remove the cap on top to add fluid.
You have to remove the inside door panel then you can see the holding assembly
hi, i could'nt find the inertia switch on my ford probe 1994 for ages. Eventually I found it just above the wheel arch on passenger side in boot but you have to remove the plastic covering. Not easy to locate. Hope this helps.
under the hood on the drivers side
It is on the passenger side of the radiater. The surge tank and cap are on the driver side
driver side fron kick panel
It is connected to the starter.it is on the driver side of the engine at the back side.
On the passenger side, under a cover in front of the door, on the side of footwell
The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
The slave cylinder on a 1991 Ford Probe is located on the transmission, typically mounted on the side of the bell housing. It is responsible for engaging the clutch when the pedal is pressed. To access it, you may need to lift the vehicle and remove any obstructions, such as the starter or other components, depending on the specific model and configuration.
Firing Order Is 1-3-4-2
Under the passenger side of the dashboard.