5/8 plug wrench
try changing plugs and wires then move to coils. if not there it could be and o2 sensor.
with a spark plug sockett
The fuel/air adjustments on these carbs are factory sealed and cannot be adjusted. There have been many that have drilled these plugs out and attempted to make the adjustments but, I just can't recall anyone that was successful in performing this procedure. In the end, they had to have them replaced.
remove the coil pack; use a jointed extension with sparkplug socket to reach plugs.
to remove the front plugs, first remove the plastic cover that is next to the small heat sink. then remove the next plastic panel. the plugs have no wires, but have boots around them. the first 3 are forward facing and are relatively easy to remove. the other 3 are in the rear and are significantly more difficult to access. Then use a plug wrench to remove plugs and replace with new plugs.
To change the spark plugs on a 1996 Oldsmobile Aurora, first, disconnect the battery to ensure safety. Remove the engine cover if necessary, then locate the spark plugs, which are typically beneath the ignition coils. Unscrew the ignition coils, carefully pull them out, and then use a spark plug socket to remove the old spark plugs. Install the new spark plugs, ensuring they are properly gapped, reattach the ignition coils, and reconnect the battery.
where would the spark plugs at on a Oldsmobile 1989 engine
On a 1997 Oldsmobile Achieva SL, the spark plugs are located on the engine, beneath the ignition coils. To access them, you typically need to remove the engine cover and the ignition coil pack, which sits directly above the spark plugs. The spark plugs themselves are threaded into the cylinder head and can be accessed once the ignition coils are removed.
Remove the four bolts on the cover plate and lift straight up exposing the wiresets.
To access the spark plugs in a 1998 Oldsmobile Delta 88, first, open the hood and locate the engine. Remove any necessary components that may obstruct access to the spark plugs, such as the engine cover or ignition coils. The spark plugs are typically located on the engine's cylinder head, so you may need a ratchet and socket to remove them. Ensure the engine is cool before starting the replacement process.
how do change the spark plugs and the coil pack on a 2000 Oldsmobile intrigue
It is but is easier if you remove the brace between the two strut towers