Removing a spare tire on a 1998 Blazer is very east. The tire is located under the rear of the blazer. The tire has a turn handle that will release the tire. Turn the handle until the tire releases.
A 98 Blazer S10 has 5 lugs on each wheel.
Remove the tire and wheel from your 1998 Chevrolet blazer. Remove the ball joint nut. Pound the ball joint out with a hammer. Reverse the process to install the new ball joint.
The spare tire is supposed to be inside that back panel on the passenger side of the car, unless someone removed it previously
On the frame rail in front of the spare tire.
No
Yes, the doors from a 98 Chevy Blazer will fit a 2001 Chevy Blazer with a little moderation.
The 1998 Chevrolet Blazer door panel is held in place by eight retaining clips. Pry outward on each retaining clip to remove the door panel.
how to in stall a Quarter Window in a 98 Chevy blazer
the temperature control actuator is on top of the heater box under the dash. you have to remove the dash to get at it. a repair manuual will show what screws to remove
just go to this address: http://www.installdr.com/InstallDocs/GM/PDF/460001.pdf
1. first retrieve cranking tool from underneath the back seat. 2. open the rear door 3. look for small hole above the bumper in the center of the car 4. put cranking tool into hole and insert into connecting hole. 5. crank counter clockwise to lower tire 6. release chain from spare 7. remove tire 8. dont forget to crank chain back up
Yes.