0
To remove the throttle position sensor (TPS) from an Oldsmobile 98, first, disconnect the negative battery cable to ensure safety. Next, locate the TPS on the throttle body, and unplug the electrical connector attached to it. Remove the screws or bolts securing the TPS in place, then carefully pull it off the throttle body. Finally, install the new TPS by reversing the steps, ensuring it is properly aligned and secured.
What else can I help you with?
How do you remove the hubcap of a 1983 Oldsmobile Regency 98?
Check on the internet
Where Tps located on an 1996 Oldsmobile ciera 3.1l?
wher is the TPS located on a 96 oldsmobile ciera 3.1L ?
Where are the horns located on an Oldsmobile 98?
where is the location of the horns on a 1990 Oldsmobile 98
Where can one find Throttle Position Sensor - TPS recommended volt settings for 1990 Regency 98 Oldsmobile?
I would recommend getting the Haynes repair manual for your car and all that information is there.
Where is the ecm located on a 1993 Oldsmobile regency 98?
ecm location 93 oldsmobile 98
What is the oil filter capacity of an 1985 Oldsmobile 98 regency brougham?
5 quarts if you remove and replace filter.
How do you remove the rotary dimmer switch from a 1992 Oldsmobile elite 98?
It comes out with a screwdriver - it is held in place with plastic clips.
How do you remove the rotary dimmer switch on a 1992 Oldsmobile 98 elite?
It comes out with a screwdriver - it is held in place with plastic clips.
Where is the heater core located in your 1996 Oldsmobile 98 regency?
please tell me how to remove the heater to get too the heater coil
How do you replace a TPS on a 1998 Oldsmobile Cutlass?
To replace the throttle position sensor (TPS) on a 1998 Oldsmobile Cutlass, first disconnect the negative battery terminal to ensure safety. Locate the TPS on the throttle body, disconnect the electrical connector, and remove the mounting screws holding the sensor in place. Replace it with the new TPS, secure it with the screws, reconnect the electrical connector, and finally, reconnect the battery terminal. After installation, it may be necessary to reset the vehicle’s computer by disconnecting the battery for a few minutes.
1991 Oldsmobile 98?
... what about it..?
How do you remove timing chain cover on 1990 Oldsmobile 98?
I need to know where the timing chain is located in a 1988 Olds 98 regency brougham, and how expensive a timing chain is.
