answersLogoWhite

0

To remove the back seat from most GM vehicles, Lift the front of the seat section then pull the seat forward. After the seat bottom is removed, there should be a couple bolts holding the bottom of the seat back into place. After removing those bolts you should be able to lift the seat straight up and remove it.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

How do you change a front drivers side turn signal on a 1991 Chevy Corsica?

Remove the wiring harness from the back of your 1991 Chevy Corsica turn signal. Remove the turn signal retaining bolts. The entire turn signal will come out. Reverse the process to install the new turn signal.


How do you replace the alternator on a 1989 Chevy Corsica?

Begin by removing the alternator belt on your 1989 Chevy Corsica. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.


How to change blower motor on 1996 Chevy Corsica?

Remove the wiring harness from the back of your 1996 Chevy Corsica blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.


Where is the throttle position sensor located on a 1991 Chevy Corsica 2.2L 4 cylinder?

its behind the coil packs on the back of block


How do you remove the back seat off a 1993 Chevy Corsica?

Push back on the bottom of the bench seat (takes a lot of pressure) to release holding clips Lift bench out Back of seat is secured by clips or bolts that are now accessible - remove these and lift upward on back of seat to release upper clips Remove seat back


How do you change a velocity joint in a 1996 Chevy Corsica?

To change a velocity joint in a 1996 Chevy Corsica, you will need to first lift the vehicle and remove the wheel. Then, disconnect the drive shaft from the transmission and remove the old velocity joint. Install the new velocity joint, reconnect the drive shaft, and put the wheel back on before lowering the vehicle.


How do you remove back brakes on a Chevy surrban2002?

how to remove back brakes on a 2002 Chevy surban


Where is the transmission modulator on an '88 Chevy Corsica?

On the back of the trans. There should be a vacuum line running to it.


How do you reset ecu on 1991 Chevy Silverado?

On that year, You can just REMOVE the battery cable for about 10 mins. Then hook it back up.


Where is the TCC solenoid located on a 1990 Chevy Corsica 3.1 engine transmission?

The 1990 Chevrolet Corsica TCC transmission solenoid is located on the top of the transmission. The solenoid will be near the back of the transmission.


Does the 1996 Chevy Corsica have front and back ABS?

If this car was special ordered with ABS it included fron and rear control.


Where is the freon filler port on a 1994 Chevy Corsica?

if you have a 3.1v6 it is between the firewall and the valve cover on the back side of the engine.