0
What else can I help you with?
How do you replace 1989 jeep Comanche clutch slave cylinder?
Remove the transmission to excess the inturnal slave cylinder
Where is clutch slave cylinder on a 1999 Chevy s10?
It is inside of the transmission bell housing. You will have to remove the transmission to service it.
What does the clutch slave cylinder look like?
It is inside of the transmission bellhousing, You can't see it until you remove the transmission.
How do you change a clutch slave cylinder on a 1988 Chevy S10 Pickup?
You will need to remove the transmission to replace the clutch slave.
How do you remove the hydraulic clutch cylinder 89 ford bronco II?
Remove the exaust pipes. Remove the transmission. It is located inside the bell housing section of the transmission.
How to remove Clutch slave cylinder S10?
the slave clutch cylinder is located inside the housing of the clutch/transmission. Unless you really know what you are doing a trained tech probably should replace this part.
How do you remove and replace the clutch cylinder on a 1999 Chevy s-10?
To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.
How do you replace a clutch slave cylinder on a 1991 YJ Wrangler?
You will have to remove the transmission since the slave cylinder on the 91 yj is inside the bellhousing.
How do you replace the clutch on a 1996 Isuzu Rodeo?
Make sure you disconnect the slave cylinder and take out of the transmission before you remove the transmission. Remove transmission, remove pressure plate & throw out bearing, and your clutch will fall off. Then just do in reverse - make sure you line the splines on the clutch. You can get an alignment tool from the parts house to make the transmission go in easier.
Do you have to remove the slave cylinder from a 2004 f150 by removing the tansmision?
Yes , the slave cylinder for a HYDRAULIC clutch is inside the manual transmission bellhousing. It slides over the transmission input shaft and is bolted to the transmission
How do you remove the hydraulic clutch cable from the transmission on a 93 Ford Ranger 5 speed trans?
The hydraulic clutch slave cylinder is located on the mainshaft of the trans. You must remove the trans to get to it
Where is the slave cylinder located on a 1998 Chevy K1500 6 cylinder?
Under passenger side of truck right below the starter. The slave cylinder for the clutch is in the Transmission Bell housing. You have to remove Transmission to repair it.
