Under passenger side of truck right below the starter. The slave cylinder for the clutch is in the Transmission Bell housing.
You have to remove Transmission to repair it.
How do you replace a slave cylinder in a 96 chevey k1500
should be located on the bell housing
The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.
The clutch slave cylinder is located inside the transmission bellhousing. The transmission must be removed to gain access.
The clutch bleed valve on a 2.2 liter Chevy Ecotec engine is located on the slave cylinder. To find the slave cylinder remove the battery, as it is mounted underneath the battery tray.
You will have to remove the transmission and then look inside of the bellhousing and you will see the slave cylinder bolted in with 2 10mm bolts. remove the 2 bolts and slide the slave cylinder off the jack shaft.
where is the slave cylinder located on a 2004 satern vue
slave is on passenger side near your starter// follow the line from the master cylinder if you get under the truck behind the front passenger wheel you won't be able to miss it.
The slave cylinder for your hydraulic clutch is located inside the manual transmission bellhousing
In a 1989 Chevy Beretta GT, the clutch slave cylinder is located on the transmission, typically mounted on the driver's side. It is positioned near the bell housing, where it connects to the clutch fork. Accessing it may require removing some components for better visibility and reach.
The slave cylinder for a hydraulic clutch is located inside the manual transmission bellhousing
i have an s-10 myself and need to replace that too,but to answer your question i was told it is inside of the transmission.