answersLogoWhite

0


Best Answer

The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the slave cylinder located on a 2000 Chevy S10?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is slave cylinder located on a 2000 Chevy s10?

i have an s-10 myself and need to replace that too,but to answer your question i was told it is inside of the transmission.


How do you connect the hydraulic to the clutch slave cylinder on a 2000 S10 chev pickup 2.2 4 cylinder?

how do you connect the hyraulic master cylinder to the clutch slave cylinder on a 2000 chevy S10 pickup 2.2 4.cylinder


Where is the slave cylinder located for a 2000 Saturn 4 door?

under the battery tray


How do you put fluid in the slave cylinder on a 2000 Toyota Tacoma?

Remember, keep the master cylinder full so you don't suck air into the slave cylinder. Then you put the fluid in the slave cylinder.


Where is the distributor cap on the 2000 Chevy Tracker?

The distributor is located on the rear of the engine next to the firewall on a 2.0 4 cylinder.


Were is the slave cylinder on a 2000 gmc sonoma?

Inside the tranny


Where is the ecm located in a 2000 Chevy Malibu ls?

Where is the ecm located in a 2000 Chevy Malibu


Where Is The Fuel Injector located In 2000 Chevy Camaro?

It has a multi-point fuel injection system with one injector on each cylinder.


Where is the crank sensor located on a 2000 Chevy Cavalier 4-cylinder 22L?

it is next to the coils at the rear of the engin between the tranmission and the engin


Where is horn located on a 2000 chevy caliver?

The horn is located in the center of the steering wheel on the 2000 Chevy Cavalier.


Where is the engine block coolant drain plug located on 2000 Chevy s10 four cylinder?

Rear of the engine block, near the oil pan.


Is the clutch master cylinder and slave cylinder on a 2000 Ford F350 one unit?

no. the clutch master cylinder is under the hood, typically near the brake master cylinder, and the slave cylinder is underneath, connected to the fork and throwout bearing on the transmission.