under the battery tray
The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.
how do you connect the hyraulic master cylinder to the clutch slave cylinder on a 2000 chevy S10 pickup 2.2 4.cylinder
Remember, keep the master cylinder full so you don't suck air into the slave cylinder. Then you put the fluid in the slave cylinder.
i have an s-10 myself and need to replace that too,but to answer your question i was told it is inside of the transmission.
Inside the tranny
The starter on a 2000 Saturn SL is located on the bottom, left side of the engine. It is powered directly by the vehicle's battery.
no. the clutch master cylinder is under the hood, typically near the brake master cylinder, and the slave cylinder is underneath, connected to the fork and throwout bearing on the transmission.
Probably on top of the slave cylinder
Yes , the slave cylinder for your hydraulic clutch is inside the manual transmission bell housing. It slides over the input shaft to the transmission and is bolted in place inside the transmission . To CHANGE the slave cylinder the transmission has to be removed , but the lines to the slave cylinder CAN BE BLEAD from a fitting that extends outside of the transmission bellhousing
If it goes to the floor with no pressure, chances are the Slave Cylinder is gone, or you are out of fluid and have a leak somewheres. But chances are if you're losing fluid, it is your slave cylinder leaking.
An alternator in a 2000 model year Saturn LS1 is located in the engine compartment. It is on the lower left of the passenger side of the car.
The Saturn L series transaxle is in front of the driver, connected to the engine.