Ford F-150
DIY Projects

Is slave cylinder on 2000 f150 4.2 inside transmission?

234

Top Answer
User Avatar
Wiki User
Answered
2009-02-12 16:20:01
2009-02-12 16:20:01

Yes , the slave cylinder for your hydraulic clutch is inside the manual transmission bell housing. It slides over the input shaft to the transmission and is bolted in place inside the transmission . To CHANGE the slave cylinder the transmission has to be removed , but the lines to the slave cylinder CAN BE BLEAD from a fitting that extends outside of the transmission bellhousing

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


i have an s-10 myself and need to replace that too,but to answer your question i was told it is inside of the transmission.


The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.


no. the clutch master cylinder is under the hood, typically near the brake master cylinder, and the slave cylinder is underneath, connected to the fork and throwout bearing on the transmission.


Remember, keep the master cylinder full so you don't suck air into the slave cylinder. Then you put the fluid in the slave cylinder.


how do you connect the hyraulic master cylinder to the clutch slave cylinder on a 2000 chevy S10 pickup 2.2 4.cylinder





It is inside the transmission pan on the valve body.It is inside the transmission pan on the valve body.


The 2000 Chevy S-10 four cylinder automatic transmission pickup truck remains one of the most common small trucks on the road today. When empty, it will take between five and six quarts of transmission fluid.Ê


i need to know if the transmission will work from a 10 cylinder to a 5.9


If it goes to the floor with no pressure, chances are the Slave Cylinder is gone, or you are out of fluid and have a leak somewheres. But chances are if you're losing fluid, it is your slave cylinder leaking.


Inside the transmission. It can be accessed with removal of the transmission pan.


There can be several things that will cause your 2000 Dodge Durango transmission to slip into reverse. A malfunctioning slave valve can cause this to happen.


On the four cylinder, it is on the driver side end of the cylinder head. On the six cylinder it is inside the distributor.



The backup sensor is inside the transmission.



Shift solenoids are inside the transmission.


Inside the transmission, on the valve body.


Inside the transmission, on the valve body.


All solenoids are inside the transmission on the valve body.All solenoids are inside the transmission on the valve body.


A 2000 Chevrolet Lumina has a modulator valve located on the side of the transmission. It is designed to control pressure inside the transmission and adjust shifting.


It is inside the transmission, on top of the valve body.


You can change the cylinder in your 2000 Chrysler Town n County by removing the head. Remove rod bolts from the crank. Push the cylinder out. Reverse the process to install the new cylinder.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.